- Turn the ignition switch to the ON position, do not start the engine.
- Fully depress the accelerator pedal slowly three times within 10 seconds.
- Turn the ignition switch to the OFF/LOCK position.
People ask also, how do you reset the oil change light on a 2012 Jeep Grand Cherokee?
In this regard, how do you reset the oil change light on a 2010 Jeep Grand Cherokee?
Also the question is, how do you reset the oil change light on a 2014 Jeep Grand Cherokee?
As many you asked, how do you reset the oil change light on a 2011 Jeep Grand Cherokee?
Contents
How do you reset the oil life on a Jeep Grand Cherokee?
How do you reset the change oil light on a Jeep?
Without starting the engine, turn the ignition in the ON/RUN mode position. In the instrument cluster display, navigate to “Vehicle Info” then “Oil Life.” Push and hold the ‘OK’ button until the oil life gauge resets to 100%.
How do you reset the oil life on a Jeep Compass?
How do you turn off the check engine light on a 2011 Jeep Grand Cherokee?
To turn off the Jeep Grand Cherokee check engine light, turn the ignition switch to ON but don’t start the vehicle. Press the gas pedal 3 times within 10 seconds and turn the ignition off. Wait 10 seconds and start the engine.
How do I reset my oil life?
Hold the Reset Button and Turn the Key Turn the ignition back to the ON position while holding the reset button. Watch the oil change or maintenance light carefully. It should start to blink. Allow the light to blink ON and OFF for a few seconds, then release the reset button and turn the ignition OFF.
How often should you change the oil in a Jeep Grand Cherokee?
Jeep recommends getting your Jeep Grand Cherokee oil & filter changed every 3,000-5,000 miles for conventional oil. An oil change is one of the most key and dominant services for your car. Synthetic oil continually should be changed every 7,500 – 10,000 miles.
How do I reset my Jeep Cherokee?
- Disconnect the battery by removing the positive battery cable.
- Ground the positive cable to the negative cable for 30 seconds to erase the electric charge in the capacitors.
- Reconnect the positive cable to the battery.
- Turn the key to on but do not start.
- Turn the headlights on.
Why is my change oil light on when I just changed my oil?
The light could be on after an oil change because of an issue with the oil pump. If this is the cause, there could be not enough oil circulating through to the various parts. Performing regular oil changes should help prevent this from happening, but parts do wear out.
Why is my oil change light still on?
If your oil light stays on even after changing your engine oil, you’re going to want to check the sensor first to rule out a malfunctioning sensor as the cause. Dirt and other particles can make their way into the oil pump, causing the sensor to falsely identify oil issues. … The next common cause is low oil pressure.
Does Jeep use synthetic oil from the factory?
Does Jeep Use Synthetic Oil From The Factory? This is regular oil and the exact same oil found in your engine when you purchased it from the dealership. If you were to have your Jeep serviced at the dealership they would use this oil. The factory service manual recommends an oil change every 3000 miles.