- Turn ignition to ON.
- Switch radio on.
- Wait 10 seconds and turn the radio off.
- Press and hold the power button until the radio resets.
Quick Answer, how do I get my jeep radio to work?
Likewise, how do you reset the radio on a 2014 Jeep Wrangler? Pop the hood of your Jeep Wrangler. Unhook the battery, starting with the negative connector (black) and then finishing the job with the positive connector (red). Removing your battery for about an hour should perform a “hard reset” of your MyGIG radio system.
Best answer for this question, how do you reset the radio in a 2013 Jeep Wrangler? Registered. If it’s the original Jeep radio, the only way to reset is to disconnect from power for 5+ minutes, then hook it back up. You can emulate this by disconnecting the battery for the same amount of time, then reconnecting it.
Frequent question, how do you reset the sound on a Jeep? Turn off your vehicle and wait for the UConnect display to go completely black. Afterwards, open and close the driver’s door and restart the vehicle. Upon restarting the vehicle, the UConnect system, along with its radio, should be reset.
Contents
How do I unlock my car radio without the code?
Turn on your radio and see if it displays CODE or LOC. If it does, turn off the radio. Press and hold down the audio power button together with the SEEK button for about 50-60 minutes. Then, it will turn on without entering the radio code.
How do I calibrate my Jeep touch screen?
Hold the up, down, and front defrost buttons simultaneously for about 5 seconds and then you are presented with the “Dealer Mode” menu. – Hold down the up, down, and Browse/Enter buttons simultaneously for about 5 seconds. That puts you into touchscreen calibration mode.
What if the Uconnect is not working?
Perform a hard reset in the phone by removing the battery (if removable – see your phone’s owner’s manual). Delete the pairing history in your phone and Uconnect® system, which is usually found in the phone’s Bluetooth® settings. Verify you are selecting “Uconnect” in the discovered Bluetooth devices on your phone.
How do I reset my Uconnect radio?
- Turn your key in the ignition to “Run,” but leave the car in park.
- Simultaneously press the volume button and the tuner knob at the same time.
- Continue pressing them down for 10 – 20 seconds.
Why isn’t my screen working in my Jeep?
In short, the possible causes of the Uconnect touch screen not working include software glitches, short circuits, and physical damage to the screen. The fixes include soft reset, hard reset, firmware upgrade, and replacing the screen.
How do you soft reset jeep radio?
Why is my Jeep touch screen not working?
The Jeep Grand Cherokee touchscreen not working can be due to multiple different things such as a short or disconnected power cable under the dash, a software glitch or issue, and it could also be a blown fuse or damage to the screen.
How do you turn the screen on a Jeep Wrangler?
How do I get the code for my jeep radio?
How do I reset my 2012 Jeep radio?
To reset the 2012 jeep grand cherokee radio you will do so by holding down the two dial button which are volum and broswe/enter for ten seconds and this will reset the radio.