You can replace a serpentine belt with ordinary hand tools. But we don’t recommend it. The spaces are often tight and the belt-driven devices difficult to reach. … The belt placement tool allowed us to remove and properly place the new belt without reaching down into the pulley area.
Likewise, how much does it cost to replace a serpentine belt on a Jeep Wrangler? Jeep Wrangler Serpentine Belt Replacement Cost Estimate. Labor costs are estimated between $45 and $57 while parts are priced between $55 and $67. This range is based on the number and age of Jeep Wrangler‘s on the road.
Also, when should I change the serpentine belt on my Jeep Wrangler? 5 years/75k miles seems like a good time to change it. Also whenever you replace the alternator or water pump. I had one fail on a Grand Cherokee V8 at 56k miles(!) but the JK 3.6 belt seems more durable.
Also know, how do you change a jeep serpentine belt?
People ask also, how expensive is it to replace a serpentine belt? A typical serpentine belt start at around $25 and goes up to $75 at most. If you know some car repair basics, you could change the belt yourself, and it may save you paying labor charges somewhere between $75 and $120. All together, you’re looking at around $100 to $195 to replace your serpentine belt.
Contents
Does Walmart replace serpentine belts?
Walmart does replace serpentine belts at some Auto Care Centers as of 2021. The price can range from $150 – $200 for replacing the serpentine belt, which includes the belt and labor. It is recommended to call your local Walmart Auto Care Center beforehand to see if the store offers this service.
Can I drive with a bad serpentine belt?
Under no circumstances can you drive a vehicle without a serpentine belt because the serpentine belt serves the important function of delivering antifreeze to important parts of the engine. The serpentine belt drives the water pump, and without it, there is insufficient coolant flow to maintain the engine temperature.
Will a car start without a serpentine belt?
The short answer is yes, your car will start even if the serpentine belt is broken or missing. To get the car going, the battery sends power to your starter motor. … However, you do need your serpentine belt if you want the car to run for longer than a few minutes.
How often do serpentine belts need to be replaced?
How often does a serpentine belt need to be replaced? Serpentine belts are built to last—much longer than before because of advancements in rubber technology. Under ideal conditions, a belt should stick with you for an average of 60,000 to 100,000 miles.
How do you change a serpentine belt on a 2008 Jeep Wrangler?
How do you change a serpentine belt on a 2006 Jeep Wrangler?
How do you replace the idler pulley on a Jeep Wrangler?
How do you release a tensioner?
If equipped with a tensioner screw, back off the tensioner screw. Then, push the alternator toward the other pulleys, loosening the belt. To loosen an NAI tensioner, loosen the locking nut or bolt, then back off the tensioner screw. Push the pulley toward the other pulleys or accessories, loosening the belt.
How tight should a serpentine belt be?
The required measure of tension in the serpentine belt is that it should not deflect more than ½ inch when twisted either way from the middle. If twisted more, the belt is loose, and if twisted less, the belt is too tight.