- Without starting the engine, turn the ignition in the ON/RUN mode position.
- In the instrument cluster display, navigate to “Vehicle Info” then “Oil Life.”
- Push and hold the ‘OK’ button until the oil life gauge resets to 100%.
Also the question is, how do you turn off the change oil light on a Jeep Wrangler?
- Put your Jeep in “Park” and turn off the engine.
- Turn the ignition to the “On” notch, without starting the engine.
- Push the gas pedal to the floor three times (within ten seconds). Turn the ignition to “Off,” and then start the engine to verify that the alert is turned off.
Similarly, how do you reset the change oil light on a 2008 Jeep Wrangler?
In this regard, how do you reset the oil change light on a 2010 Jeep Wrangler?
Amazingly, how do you reset the oil change light on a 2012 Jeep Wrangler?
Hold the Reset Button and Turn the Key Turn the ignition back to the ON position while holding the reset button. Watch the oil change or maintenance light carefully. It should start to blink. Allow the light to blink ON and OFF for a few seconds, then release the reset button and turn the ignition OFF.Contents
Does Jeep use synthetic oil from the factory?
Does Jeep Use Synthetic Oil From The Factory? This is regular oil and the exact same oil found in your engine when you purchased it from the dealership. If you were to have your Jeep serviced at the dealership they would use this oil. The factory service manual recommends an oil change every 3000 miles.
How do you reset the oil light on a 2011 Jeep Wrangler?
How do I reset my oil change light on my Jeep Grand Cherokee?
- Turn the ignition switch to the ON position, do not start the engine.
- Fully depress the accelerator pedal slowly three times within 10 seconds.
- Turn the ignition switch to the OFF/LOCK position.
How do you reset the maintenance light on a 2014 Jeep Wrangler?
How do you reset the oil life on a 2020 Jeep Wrangler?
How do you reset the oil light on a 2015 Jeep Wrangler?
- Turn the ignition to run (one position before starting engine).
- Fully depress the accelerator pedal slowly three times within 10 seconds.
- Turn the ignition off and then start the engine to verify the indicator has been reset.
How do you reset the oil life on a 2017 Jeep Wrangler?
To reset the oil life on the 2017 jeep wrangler, turn the key to on, press on the accelerator slowly 3 times in a span of 10 seconds, then turn ignition to off.
Why does my jeep keep saying oil change required?
The engine oil change indicator system is duty cycle based, which means the engine oil change interval may fluctuate dependent upon your personal driving style. … Unless reset, this message will continue to display each time you turn the ignition switch to the ON position.
How do you reset the check engine light on a Jeep Wrangler?
- Make sure the engine is not running and key is out of the ignition.
- Disconnect the battery terminals.
- Wait 5 minutes.
- Reconnect battery terminals.
- Insert and turn the ignition key to the run position without starting.
- All error codes are cleared and CHECK ENGINE icon disappeared.