Subsequently, how do you remove side marker lights?
People ask also, how do you change the side marker light on a Jeep Wrangler TJ?
Also the question is, how do you change the rear view mirror lights on a Jeep Wrangler?
- Step 1 – Remove the rear view mirror. Use the screwdriver to remove the mounting bolt on the roof of the Jeep.
- Step 2 – Disassemble the rear view mirror. Unlike other map lights, the bulbs inside the mirror are soldered in place.
- Step 3 – Replace the bulbs.
- Step 4 – Reassemble the rear view mirror.
Similarly, how do I reset my Jeep Wrangler warning light? Without starting the engine, turn the ignition in the ON/RUN mode position. In the instrument cluster display, navigate to “Vehicle Info” then “Oil Life.” Push and hold the ‘OK’ button until the oil life gauge resets to 100%.
Contents
How do you replace side marker lights?
Remove the bulb and socket from the side marker lens assembly, a counterclockwise twisting motion usually will allow you to pull the socket out of the lens. Unbolt or unscrew the side marker light assembly from the vehicle and remove the damaged assembly. Install new side marker light assembly on the vehicle.
How do you change a turn signal bulb in a Jeep Wrangler?
How do you change a turn signal switch on a Jeep Wrangler?
How do you take the mirrors off a Jeep Wrangler?
How do you remove the rear view mirror on a Jeep Wrangler?
How do you remove a rear view mirror bulb?
How do you check the codes on a Jeep Wrangler?
- Insert key into the ignition.
- Turn to “ON” position without starting the Jeep.
- Push the key in and turn it to “OFF” and then to “ON” three times, leaving it in the “ON” position.
How do I turn my check engine light off?
Why is my check engine light on in my Jeep Wrangler?
Jeep Wrangler Check Engine Light Flashing Other common reasons for a Check Engine Light are faulty head gasket, a malfunction with the fuel injection system, dirty mass airflow sensor, faulty emissions control part, damaged oxygen sensor, or defective spark plugs to name a few.