Turn ON your ignition without igniting your engine for about 2 seconds, then turn OFF the ignition for 10 seconds. Turn ON the ignition again for 2 seconds and turn it OFF for 10 seconds. This will notify your computer system of the new position of your gas pedal and closed position.
Beside above, how do you reset the electronic throttle control on a Jeep Wrangler? Step 1: Turn the Jeep to the “on” position but not the engine running position. Step 2: Wait for all of the dummy lights to turn off (check engine light will stay on). Step 3: Depress the accelerator REALLY slowly… Driving Miss Daisy with a touch of Cocoon slowly…all the way to the floor.
Subsequently, how do I reset my electronic throttle control system? Resetting your electronic throttle control manually can be a tricky job. First, make sure the accelerator pedal is fully released. Next, turn the ignition on and then turn it off and wait for ten seconds. During these ten seconds, be sure the throttle valve is moving by listening for a sound of operation.
Quick Answer, how do I fix my electronic throttle control?
In this regard, what causes the ETC light to come on? It is caused by an intermittent loss or disruption of the electronic signal from the gas pedal to the throttle. Your throttle will operate normally some of the time, but at other random times it will accelerate either not enough, or too much.Just re-set the APPS, by unplugging it when running and shutdown , restart plug it back in , shutdown go to ACC/RUN do not start clear code and see what happens, You will need Alfa or WITech to remove Service electronic throttle control.
What does the red lightning bolt mean on my jeep?
The lightning bolt warning light is your Electronic Throttle Control, or ETC, Warning Light. If you see this light it indicates there’s a problem with that particular system. While this doesn’t mean that you need to pull over immediately, you should still get this checked out by your mechanic.
How much does it cost to reprogram a throttle body?
Installation prices will be low due to the easy accessibility of the throttle, so look to pay in the $50 to $75. However, some sensors and almost all of the assemblies will need to be reprogrammed, and will add anywhere from $20 to $100 to the installation bill.
How do you reset etc?
You can try resetting the ETC as well. Place you vehicle in the run position without starting and depress the gas pedal and release all in 2 seconds (1 down and 1 up). You should hear a confirmation “ding” if done correctly and you have know reset the sensor to know when you have open throttle.
What happens when the electronic throttle control goes bad?
When a TPS goes bad, then the car’s throttle body won’t function properly. It could either stay shut or it won’t close properly which is a severe issue. … When the throttle gets stuck in an open position than your vehicle will receive too much air and cause it to have a high or fluctuating idle.
Can you drive with a bad electronic throttle control?
Can you drive with a bad throttle position sensor? … If you have a bad throttle position sensor, your car will not perform well or safely. Driving with a bad throttle position sensor may also cause problems in other related systems in your car, which will mean additional repair bills.
How do I know if my electronic throttle body is bad?
- Stalling.
- Unstable idle.
- Rough running.
- Illuminated check engine light.
- Reduced power warning message on the dash.
How much does it cost to fix an electronic throttle control system?
Electronic Throttle Control Repair Cost – Here’s What You Need To Know. Since this is such a key part to every car’s internal system, the average cost for this repair can be quite pricey – the average electronic throttle control repair cost comes out to around $645!
What is a powertrain warning light?
The powertrain is usually referring to your car’s engine system. … Generally, this indicator light means a problem has been detected in the automatic transmission (not applicable in manual transmission cars) or transaxle. This light can also indicate an Electric Shift Control system warning.
What is a ETC light?
This light informs you of a problem with the Electronic Throttle Control (ETC) system. If a problem is detected while the vehicle is running, the light will either stay on or flash depending on the nature of the problem.
What does lightning bolt mean on car?
The lightning bolt warning light alerts you to a fault in the electronic throttle control system in your vehicle. This may be a faulty throttle body, the throttle body sensor or possibly the throttle body control motor which is what controls the opening and closing of the throttle body as the motor requires more fuel.