To reset the gas cap light in your Jeep Wrangler, turn off the engine and push the button to unlock the door to the gas tank. Open the door, remove the cap, put the cap back on, and close the door. The light should reset.
Also the question is, how do you reset the codes on a 2011 Jeep Wrangler?
- Make sure the engine is not running and key is out of the ignition.
- Disconnect the battery terminals.
- Wait 5 minutes.
- Reconnect battery terminals.
- Insert and turn the ignition key to the run position without starting.
- All error codes are cleared and CHECK ENGINE icon disappeared.
As many you asked, why does my jeep keep saying gas cap? It’s telling you there is a leak somewhere in the Evaporative Emissions System. If it detects a leak, and it happens to be soon after you filled the gas tank, it will assume you have not properly installed the gas cap, and will give you that warning.
Amazingly, how do you reset check engine light after loose gas cap?
- Turn off your vehicle’s engine.
- Step to the gas cap door.
- Replace the gas cap.
- Close the gas cap door.
- Use an OBD-II code scanner if the warning light does not disappear.
- Continue driving the vehicle.
Considering this, why does my 2011 Jeep Wrangler say gas cap?
Contents
How many miles does it take to reset a jeep computer?
For good measure. Anytime that you reset your Jeep PCM you should keep in mind that you will need to drive your car for approximately 10-15 miles so your Jeep ECM can re-learn your driving habits and fuel management.
How do you reset the gas cap on a Jeep?
To reset the gas cap light in your Jeep Wrangler, turn off the engine and push the button to unlock the door to the gas tank. Open the door, remove the cap, put the cap back on, and close the door. The light should reset.
Where is the gas cap on Jeep?
To open the fuel filler door, You will need to open Your driver’s side car door. Now, right on the left side of the driver’s side dash You should see a knob where You change the headlights. Right below that knob is a small round button with a gas tank on it. Push the button where the gas tank symbol is located.
What causes the gas cap light to come on?
Simply put, if your fuel cap light is on, it means that the computer has detected a leak in the system, typically from a loose gas cap. If this light comes on while driving, pull over in a safe spot and re-secure the cap. Continue driving normally with the light illuminated and it should go off within a day or two.
How long does it take for the check engine light to reset after a loose gas cap?
So why is the light still on? Here’s something you probably don’t know: after clearing the car’s computer you will need to drive for about 50 to 100 miles. As you drive your car the computer will monitor all the sensors and register the results. You can use GOFAR to constantly monitor your car diagnostics.
How long does it take for engine light to reset after gas cap?
As soon as it’s safe, pull over and make sure your gas cap is tight. Once you’re back on the road, your check engine light should go off within 10 or 20 miles.
How do I know if my gas cap is bad?
As a general rule, the symptoms of a bad gas cap include a smell of fuel from the vehicle, trouble removing or tightening the gas cap, a check engine light on the dashboard and water getting into the fuel tank.
How do you reset the gas light on a 2013 Jeep Wrangler?
How do you take the gas cap off a Jeep Wrangler?
How do you reset the gas light on a 2015 Jeep Cherokee?
When You turn the gas cap counter-clockwise You will continue to turn the cap until it clicks three times to make sure it is fastened tightly. Now You turn on the engine and drive the SUV around for about 10 minutes and the OBD-II system will automatically reset the gas cap light.