Without starting the engine, turn the ignition in the ON/RUN mode position. In the instrument cluster display, navigate to “Vehicle Info” then “Oil Life.” Push and hold the ‘OK’ button until the oil life gauge resets to 100%.
Additionally, how do you reset the oil change light on a 2011 Jeep Wrangler?
Frequent question, why does my jeep keep saying oil change required? The engine oil change indicator system is duty cycle based, which means the engine oil change interval may fluctuate dependent upon your personal driving style. … Unless reset, this message will continue to display each time you turn the ignition switch to the ON position.
Moreover, how do you reset the oil life on a 2015 Jeep Wrangler?
Furthermore, how do you reset the oil life on a 2016 Jeep Wrangler?
- Make sure the engine is not running and key is out of the ignition.
- Disconnect the battery terminals.
- Wait 5 minutes.
- Reconnect battery terminals.
- Insert and turn the ignition key to the run position without starting.
- All error codes are cleared and CHECK ENGINE icon disappeared.
Contents
How do I reset my oil light?
Hold the Reset Button and Turn the Key Turn the ignition back to the ON position while holding the reset button. Watch the oil change or maintenance light carefully. It should start to blink. Allow the light to blink ON and OFF for a few seconds, then release the reset button and turn the ignition OFF.
How do I know when my Jeep Wrangler needs an oil change?
Synthetic oil usually should be changed every 7,500 – 10,000 miles. Jeep recommends getting your 2020 Jeep Wrangler oil & filter changed every 3,000-5,000 miles for conventional oil. An oil change is one of the most central and crucial services for your car.
How do I reset my Jeep Wrangler computer?
- Step 1 – Remove the positive (red) battery cable.
- Step 2 – Ground the red cable to the negative terminal.
- Step 3 – Reconnect the positive battery cable.
- Step 4 – Turn on your Jeep.
- Step 5 – Cycle the headlights.
- Step 6 – Turn the key off and remove.
How do I change my oil change required message?
How do you reset the oil life on a jeep?
Without starting the engine, turn the ignition in the ON/RUN mode position. In the instrument cluster display, navigate to “Vehicle Info” then “Oil Life.” Push and hold the ‘OK’ button until the oil life gauge resets to 100%.
How do you reset the oil light on a 2012 Jeep Wrangler?
How do you reset the oil life on a 2017 Jeep Wrangler?
To reset the oil life on the 2017 jeep wrangler, turn the key to on, press on the accelerator slowly 3 times in a span of 10 seconds, then turn ignition to off.
How many miles does it take to reset a jeep computer?
For good measure. Anytime that you reset your Jeep PCM you should keep in mind that you will need to drive your car for approximately 10-15 miles so your Jeep ECM can re-learn your driving habits and fuel management.