Without starting the engine, turn the ignition in the ON/RUN mode position. In the instrument cluster display, navigate to “Vehicle Info” then “Oil Life.” Push and hold the ‘OK’ button until the oil life gauge resets to 100%.
You asked, how do you reset the oil life on a 2014 Jeep Wrangler?
- Turn the key to ON/RUN position with engine off.
- Fully depress and release the accelerator pedal 3 times within 10 seconds.
- Turn the key to the OFF position and then back on to confirm reset was accepted.
Similarly, how do you reset the oil life on a 2015 Jeep Wrangler?
- Turn the ignition to run (one position before starting engine).
- Fully depress the accelerator pedal slowly three times within 10 seconds.
- Turn the ignition off and then start the engine to verify the indicator has been reset.
Additionally, how do you reset the change oil light on a 2013 Jeep Wrangler?
Correspondingly, how do you reset the oil light on a 2012 Jeep Wrangler?
Hold the Reset Button and Turn the Key Turn the ignition back to the ON position while holding the reset button. Watch the oil change or maintenance light carefully. It should start to blink. Allow the light to blink ON and OFF for a few seconds, then release the reset button and turn the ignition OFF.Contents
How do I reset my Jeep Wrangler?
- Open the Wrangler’s hood and prop it up with the support bar.
- Loosen the bolt on the negative battery clamp using a ratchet and socket.
- Wait 30 minutes for the computer to reset itself.
- Put the negative battery clamp back onto the negative battery terminal and tighten the bolt.
Why does my Jeep says oil change required?
The engine oil change indicator system is duty cycle based, which means the engine oil change interval may fluctuate dependent upon your personal driving style. … Unless reset, this message will continue to display each time you turn the ignition switch to the ON position.
How do you reset the codes on a 2012 Jeep Wrangler?
- Make sure the engine is not running and key is out of the ignition.
- Disconnect the battery terminals.
- Wait 5 minutes.
- Reconnect battery terminals.
- Insert and turn the ignition key to the run position without starting.
- All error codes are cleared and CHECK ENGINE icon disappeared.
How do you reset the oil life on a 2011 Jeep Wrangler?
Why won’t my oil light go off?
If your oil light stays on even after changing your engine oil, you’re going to want to check the sensor first to rule out a malfunctioning sensor as the cause. … The oil pump may not be circulating enough oil to keep the engine’s parts lubricated and functioning properly, which can in turn cause multiple engine issues.
Why is my oil light on but I have oil?
When the oil light on your dashboard comes on, it might mean your vehicle has low oil pressure. This drop in oil pressure could be a sign of a few things: you are low on oil, your oil is dirty, or you have an oil leak.
Why is my change oil light on when I just changed my oil?
The light could be on after an oil change because of an issue with the oil pump. If this is the cause, there could be not enough oil circulating through to the various parts. Performing regular oil changes should help prevent this from happening, but parts do wear out.
How do I reset my Jeep?
How many miles does it take to reset a jeep computer?
For good measure. Anytime that you reset your Jeep PCM you should keep in mind that you will need to drive your car for approximately 10-15 miles so your Jeep ECM can re-learn your driving habits and fuel management.
How do I factory reset my Jeep?
Press and hold down the volume and tuner knob buttons at the same time. Hold down the knobs for 10 – 20 seconds. After holding down the knobs, the screen should flash your vehicle brand name and then go dark.