- Step 1 – Remove the steering column shroud. One of the first and most important steps is to disconnect the negative (black) battery cable and wait 15 minutes before proceeding.
- Step 2 – Remove the airbag module.
- Step 3 – Remove the clockspring.
- Step 4 – Install the new clockspring.
As many you asked, what does a clock spring on a Jeep Wrangler do? The airbag clock spring connects the driver’s side airbag to the steering column and ensures that electrical contact is maintained between the airbag module and the vehicle electrical system while the steering wheel is being turned.
Moreover, how do you replace a clock spring?
Subsequently, how do I know if my clock spring is bad?
- Airbag light is on – A common problem often caused by a defective clock spring.
- Horn doesn’t work – In some cases, a bad clock spring can cause the horn to stop working.
- The cruise control switch does not work – On models where the cruise control is mounted on the steering wheel.
Similarly, does a clock spring need to be programmed? Does a new clock spring need to be programmed? No, the clock spring itself will work without programming. If your clock spring has an integrated steering angle sensor, you may need to carry out a steering angle reset, reset the stability control, and ABS lights.If you try to drive a car with a faulty or broken clock spring, you will experience a lot of difficulty when you try to rotate the steering wheel, and what’s more, if you prolong this, it will cause damage to other parts of your car, too, not to mention putting yourself, as the driver, at risk.”
What happens with a bad clock spring?
A bad clock spring can afflict you with more than broken volume controls. You could be left without cruise control, a functioning horn, or most importantly, a functioning airbag. In this situation, you would be unable to alert an inattentive driver and the airbag may not deploy in the event of a collision.
Can I replace a clock spring myself?
Remove Steering Wheel Bolt Cover Clips. Remove SRS Airbag Control Module Bolts. Remove the SRS Airbag Control Module from the Steering Wheel (make sure you disconnect any electrical connectors) … Once the steering wheel has been removed, you can remove the clock spring.
How much does it cost to replace a clock spring?
For a clock spring, the parts alone will cost $80 to $150; however, if a professional mechanic is going to replace the clock spring for you, the average job will cost anywhere from $200 to as much as $400.
What does the clock spring control?
In vehicle steering systems a clock spring or clockspring is a spiral-wound special rotary electrical connector which allows a vehicle’s steering wheel to turn while still making an electrical connection between the steering wheel airbag and/or the vehicle’s horn and other devices and the vehicle’s electrical systems.
When should I replace my clock spring?
The clock spring may need to be replaced if it is damaged during careless service to the steering system, and, in some cases, if the vehicle is in a crash and the driver’s airbag deploys.
How do you test a clock spring?
What is another name for clock spring?
Alternative names for the clock springs are clock spring coil, coil assembly, cable reel assembly, coil spring unit and contact reel.
What does a clock spring look like?
How do you line up a clock spring?
What is the new hand position on a steering wheel?
NHTSA now recommends the technique known as “9 and 3”. Place your left hand on the left portion of the steering wheel in a location approximate to where the nine would be if the wheel was a clock. Your right hand should be placed on the right portion of the wheel where the three would be located.