Frequent question, how do I remove the blower motor from my Jeep TJ?
Likewise, what are the signs of a bad blower motor? You might also hear ongoing whirring noises, or noises that change or get louder if you increase the fan speed. These are all signs of problems with the blower motor. In some cases, you may even notice smoke or smells of burning while driving, in which case you should pull over immediately.
Also, where is the blower motor located on a Jeep Wrangler? On a Jeep Wrangler, the blower motor is necessary to the air conditioning, heating and defrosting systems. It is located under the dashboard on the far end of the air duct on the passenger’s side. It is easy to access and can be removed in minutes.
Also know, where is the blower motor on a 2003 Jeep Wrangler? The blower motor is often mounted under the passenger side of the dash.The blower motor is the fan that pushes heated or cooled air through dashboard vents based on the climate system settings and the fan speed selected. … Many vehicles have two fuses for the blower motor, one in the interior fuse block and the other under the hood.
Contents
What does a bad blower motor sound like?
A defective blower motor will make a continuous sound noticeable by the passengers in the vehicle. It can manifest as a knocking, whirring, clunking, vibrating, squealing, or whining noise that persists until the blower motor is replaced.
What can cause a blower motor to stop working?
In a situation where the motor doesn’t work on any speed, the most likely causes are: a blown power supply fuse, a bad motor ground connection, bad motor speed control module or a failed motor. On all systems, a failed blower motor is least likely.
How much should it cost to replace a blower motor?
Replacing a blower motor costs $450 on average with a typical range of $250 to $800. With a warranty, you might pay as little as $150 for labor alone. For high-end models, like those with large motors or access issues, you might pay as much as $2,000.
How do you test a blower motor resistor on a Jeep?
Place one lead of the Ohmmeter on terminal 1 of the resistor. Place the other lead on terminal 2 and check against specifications. If this circuit is open, showing infinity on the Ohmmeter, the blower resistor must be replaced. Move the lead from terminal 2 to terminal 3 and check this reading against specifications.
Where is the blower motor resistor on a 2002 Jeep Wrangler?
Where is the blower motor resistor on a 2000 Jeep Wrangler?
How do you change a blower motor on a Jeep JK?
Where is the blower motor relay on a 2008 Jeep Wrangler?
The blower motor resistor on the 2008 jeep wrangler is inside the dash on the opposite side of the steering wheel.
Does the blower motor resistor control heat?
The blower motor resistor is an electrical component that is a part of the vehicle’s heating and air conditioning system. It is responsible for controlling the blower motor’s fan speed. … A failed blower motor resistor can cause issues with the operation of the entire heating and air conditioning system.