Go to the vehicle and press unlock or lock multiple times repetitively until the indicators flash and red dash light flashes very fast for around 10 seconds. That means it’s synced and and you should be good to go. There should be no programming needed by a dealer at all.
Furthermore, how do I bypass my Land Rover Immobiliser?
Another frequent question is, how do I get my EKA code? The EKA code is found on the security information card supplied with your vehicle. The code is 4 digits long. The EKA code IS NOT the code in the key fob. The grey plastic tag on the keys IS NOT the EKA code, it is the ignition key code.
People also ask, how do I enter EKA code on defender? To enter the EKA code, turn the key to II and back to 0 the same amount of times as the first number, e.g., if your EKA code is 4321, turn the key 4 times. 6. Now open and close the door to confirm the entry.
Likewise, how do I reset my Land Rover alarm? To reset the alarm on the 2000 Land Rover Discovery, turn Your car off and make sure the front drivers side door is easily accessible. Then unlock the car and put the key into the ignition. Leave it there for at least a minute and then, set it to the RUN position. Restart the car to see if Your alarm has been reset.
Contents
How do I find my Immobiliser code?
Immobiliser codes are available online using the Vehicle Identification Number VIN, Auto Locksmiths & Auto Electricians can use the Immobiliser Code, Emergency Key Access Code (EKA) or IMMO code to start your car or van.
Can you disable a car Immobiliser?
People can use a certain method to disable immobilizer system and however most famous method is by reprogramming EEPROM chip on ECU. … Suppose you lose your car key then you must remove car immobilizer from your car. You can strip little insulation off every wire which ensures that it could not touch each other.
How do you program a defender key fob?
How do I get an emergency key access code?
The EKA code is found on the security information card supplied with your vehicle. The code is 4 digits long. The EKA code IS NOT the code in the key fob. The grey plastic tag on the keys IS NOT the EKA code, it is the ignition key code.
How do you unlock a Range Rover without a key?
How do you turn off the alarm on a Land Rover Discovery?
To disarm the alarm, press the unlock button on the Smart Key or press the START STOP button with the Smart Key inside the vehicle. Single-point entry allows only the driver’s door to unlock with a single press.
How do you cut a key in a code?
What is a Nanocom?
Custom Remap for the TDV6 – EMS Flash File [NANOCOM] A custom VBF Remap file that can be programmed into the engine management using our diagnostic server based systems applicable to Discovery 3 / LR3 or Pre 2010 Range Rover Sport with a TDV6 Diesel Engine.
How do you start a discovery key?
How do I enter EKA code P38?
- Using the ignition key insert it into the drivers door lock.
- Turn the key anticlockwise to the locking position and back to the central position 4 times.