The parking brake can be released manually: in the Discovery 3 and 4 by removing the small rectangular plastic cover situated just behind the parking brake lever. On the Range Rover Sport the EPB lever needs to be removed by unscrewing 2 screws.
In this regard, how do you manually release an electric parking brake? With the AUTO switch OFF, the EPB can be applied by pushing and holding the parking brake switch. This will work with the ignition switch ON or OFF and with the vehicle moving or stationary. To release the brake, pull and hold the manual switch while at the same time pressing the brake pedal.
Correspondingly, how do you release the parking brake on a Land Rover? With the ignition switched on, press the brake pedal and press down on the EPB switch. This will release the EPB. With the vehicle stationary, pull the EPB switch up and release it, to apply the EPB. The Parking brake warning lamp will illuminate to indicate that the EPB is applied.
Subsequently, how do I get my Land Rover Discovery out of park? Turn the locking mechanism 90° anti-clockwise. Press the brake pedal. Use the strap to pull the transmission park release mechanism upwards, until it latches in the vertical position.
Furthermore, how do you release the handbrake on a Discovery 4?
Registered. As far as I’m aware you switch on the ignition (push start/stop button without foot on the brake pedal) then pull the electronic handbrake lever so the red ‘P’ icon goes away. Then you can just push the start/stop button again to switch off the ignition (or just open the door).How do I disengage an electronic parking brake if the battery is drained?
If the battery dies, the parking brake system won’t operate. To release the parking brakes manually, a special tool is included along with the jack tools. Install the correct bit on the tool, remove the plug from the spare tire well, insert the tool and turn counterclockwise to release.
How do you release the handbrake on Discovery 3?
Where is Range Rover emergency brake?
The Electric Parking Brake (EPB) switch is located on the switch pack between the steering wheel and the driver’s door. Operate as follows: With the ignition switched on, press the brake pedal and pull the EPB switch out to release the EPB.
Does Discovery sport have a handbrake?
Improved EPB system The electronic park brake system on Discovery 3 and Range Rover Sport models continued into the Discovery 4. … The park brake system is automatically applied when the ignition is switched off or if auto transmission ‘park’ is selected.
How do you put a 2017 Range Rover in neutral?
Do electronic parking brake automatically disengage?
Most electronic handbrakes disengage automatically when pulling away. In a car with a manual gearbox, it’ll release as you bring the clutch up past the biting point and press the accelerator.
Does electronic parking brake drain battery?
Does electronic parking brake drain battery? If you are setting the E-Parking brake either manually or automatically at shutdown you run the risk of draining the battery in about 2 days.
How do you release the parking brake on a Range Rover Sport?
Press the brake pedal and press down on the EPB switch. This will release the EPB. Pull up the EPB switch and release it to apply the EPB. The EPB warning lamp will illuminate to indicate that the EPB is applied.