People also ask, how do you reset the service light on a 2013 Range Rover Evoque?
Also know, how do you reset the service light on a 2012 Range Rover Evoque?
Also, how do you turn off the service light on a Range Rover Evoque? Turn the ignition to “on” without igniting your engine (if you have push-button start, press your button once without touching the brake pedal. Open the driver’s door. Depress and hold the gas and brake pedals for 60 seconds. Then turn the ignition to “off” and verify that the light has been reset.
Furthermore, how do I access Range Rover service menu?
Contents
How do you reset the service light on a 2014 Range Rover Sport?
- Open the bonnet.
- Turn the ignition key to the “ON” position without starting the engine.
- Open the driver’s door.
- Hold the accelerator and brake pedals all the way down.
- Turn the ignition OFF and start the engine to verify the indicator has been reset.
What does it mean when the service indicator light is on?
The service required light is mainly used to remind drivers when it is time to change the oil and filter, but could be used for other fluids or components. In the past, this light was similar to the check engine light and could mean that a fault has been detected by the system.
How do you reset the service light on a 2015 Range Rover?
- Key on, engine OFF.
- Open door.
- Open bonnet (hood)
- Depress the accelerator pedal simultaneously for ten seconds, release.
- service interval is now reset.
How do you reset the service light on a Range Rover Sport?
How do you put a Range Rover in service mode?
How do I reset my Range Rover valet mode?
- From the Home menu screen, select Valet.
- Enter a memorable 4 digit PIN. You will be prompted to confirm the PIN. If you wish to cancel the PIN, select Delete.
- Valet mode activated is displayed to indicate that a PIN has been accepted.
How do you get to the message center on a Range Rover?
How do you reset the service light on a 2009 Range Rover?
How do you reset a 2011 Range Rover?
- Press and hold the trip reset button.
- Turn the ignition switch on to the ignition position II (one position before starting engine).
- If the SII (Service Indicator Interval) function is enabled the information display will flash ‘SERVICE’ for 5 seconds and then display ‘SERVICE’ constantly.