Turn the jack lever (2) clockwise to raise the jack, until it locates into the jacking point. Make sure that the base of the jack is in full contact with the road surface. Raise the vehicle with the jack, until the tyre being lifted just clears the ground. Operate the jack with a slow and steady motion.
Also know, how do you lift a Range Rover with air suspension? Up button: Press and release to raise the suspension height. If a door is open, press and hold to raise the suspension height. The button’s LED indicator lamp illuminates during suspension height adjustment and extinguishes when complete. Down button: Press and release to lower the suspension height.
Additionally, can you jack up a car with air suspension? Just jack it up like normal from ride height. Of course, you can air up higher if you need the clearance. If you’re doing any suspension work, dump the pressure once it’s on jack stands.
Also, where are the jacking points on a Range Rover Sport? To raise the vehicle, use the jacking points located on the front and rear of the side tubes, fixed side steps, or deployable side steps.
Another frequent question is, how do I reset my Range Rover air suspension?
- Press and hold to raise the rear suspension.
- Press and hold to lower the rear suspension.
- Simultaneously press and hold both buttons to set the rear suspension to the normal height setting. A time delay may be evident before the vehicle reacts to a suspension height request via the buttons.
Contents
Where is the jack in a Range Rover?
If side steps or tubes are fitted, the jacking points are located on the underside of the side step or tube brackets. Before raising the vehicle, correctly position the wheel chocks. See USING WHEEL CHOCKS. Before raising the vehicle or changing a wheel, make sure to read and comply with the following warnings.
How do you jack up a Range Rover?
Turn the jack lever (2) clockwise to raise the jack, until it locates into the jacking point. Make sure that the base of the jack is in full contact with the road surface. Raise the vehicle with the jack, until the tyre being lifted just clears the ground. Operate the jack with a slow and steady motion.
How do you lift a car with air bags?
How do you maintain air suspension?
Can I drive my Range Rover Sport in access height?
The full access height setting is 2 in (50 mm) below the normal height setting. Auto access height can be activated until 90 seconds after the vehicle becomes stationary. … Alternatively drive the vehicle at a speed above 4.4 mph (7 km/h) for 3 seconds, or at a speed in excess of 9.3 mph (15 km/h).
Can you drive your Range Rover in access height?
How do you change the wheels on a Range Rover Sport?
- Open the tailgate.
- Remove the loadspace floor panel.
- Remove the spare wheel retaining bolt.
- Remove the vehicle’s jack and the spare wheel lift assist tool.
- Attach the lift assist tool, as shown.
- Remove the tool and carefully lift the spare wheel from the vehicle.
How do you fix a suspension on a Range Rover?
How do you reset the ECU on a Range Rover Sport?
What does air suspension inactive mean on a Range Rover?
The reason it went up when they cleared the code is because they reactivated the system and the compressor filled the system… For it to just sink and throw the inactive message up minutes after the codes were cleared means there is something physically wrong, the system is losing air.