- Insert the front end of the cable in the hole in the body and push.
- Using the screwdriver, pry the cable clip up and in until it locks in place.
- Slide the new cable into the groove on the pedal assembly and seat firmly.
- Pulling the slack out of the cable as you go, re-secure all clips and clamps previously removed.
Also know, how do you remove the handbrake on a Range Rover?
Additionally, how do you adjust the handbrake on a Range Rover Sport?
Also, how do I fix my handbrake cable?
Another frequent question is, how much does it cost to replace parking brake cable? Emergency Brake Cable Replacement Cost – RepairPal Estimate. Labor costs are estimated between $136 and $172 while parts are priced at $121. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location. Related repairs may also be needed.
Contents
How long does it take to replace a handbrake cable?
A handbrake cable replacement usually takes around 1.5 hours, but can take less or more time.
How do you manually release handbrake on a Range Rover Sport?
Where is the handbrake on a Range Rover Sport?
On Discovery 3 and 4 and Range Rover Sport 1 models the electronic park brake system comprises four main parts: the driver’s switch in the cab, the brake module mounted in the centre of the chassis infront of the spare wheel, the cables that run from the module to the wheel brakes to operate them, and the brakes …
Where is Range Rover emergency brake?
The Electric Parking Brake (EPB) switch is located on the switch pack between the steering wheel and the driver’s door. Operate as follows: With the ignition switched on, press the brake pedal and pull the EPB switch out to release the EPB.
How do you adjust the handbrake on a Land Rover?
How do I remove EPB from Discovery 3?
The parking brake can be released manually in the Discovery 3 and 4 by removing the small rectangular plastic cover situated just behind the parking brake lever and on the Range Rover Sport by unscrewing the 2 screws that hold the EPB lever in place, inside is a wire cable loop, pulling this will release the parking …
How do you reset the handbrake on a Discovery 3?
With the Engine running, press the brake pedal fully on and off 3 times. On the third press, hold the brake pedal down. With the brake pedal still in the down position, pull the EPB switch upwards 4 times and then downwards 3 times. This must be completed within 10 seconds.
Is it easy to change a handbrake cable?
Replacing an exposed secondary handbrake cable is not too difficult – you can see the entire cable run under the car. It is a good idea if possible to make a sketch of exactly which brackets the cable fits to before removing it – there may be extra brackets fitted under the car for different models.
How do I know if my handbrake cable is broken?
- Parking brake won’t move. After you put the parking brake in place, if it does not disengage, chances are the parking brake release cable has been broken.
- Drag in vehicles.
- Reasons the parking brake release cable fails.
- Do not drive if parking brake is engaged.
Should you replace both handbrake cables?
Parking brake cables for both rear wheels are typically replaced at the same time. … Replacing parking brake cables is not very difficult, but requires good access to the vehicle from underneath. In some cars, the rear drum or parking brakes must be taken apart to get access to parking brake cables.