How to change wheel on range rover sport?

1. Open the tailgate.
2. Remove the loadspace floor panel.
3. Remove the spare wheel retaining bolt.
4. Remove the vehicle’s jack and the spare wheel lift assist tool.
5. Attach the lift assist tool, as shown.
6. Remove the tool and carefully lift the spare wheel from the vehicle.

People also ask, how do you lock the air suspension on a Range Rover? 2016 Range Rover Make sure that the suspension height is set at the access height setting or the normal height setting. Make sure that the vehicle is travelling at a speed of less than 35 km/h (22 mph). Press the down button (2) for longer than 1 second, to lock the vehicle at access height.

Another frequent question is, how do you take a tire off a Range Rover?

Likewise, does Range Rover Sport have a spare wheel? The temporary spare wheel is located underneath the rear of the vehicle.

Furthermore, how do you jack up a Range Rover Sport? Turn the jack lever (2) clockwise to raise the jack, until it locates into the jacking point. Make sure that the base of the jack is in full contact with the road surface. Raise the vehicle with the jack, until the tyre being lifted just clears the ground. Operate the jack with a slow and steady motion.Land Rover Range Rover Sport Active Suspension Air Spring Replacement Cost Estimate. Labor costs are estimated between $226 and $286 while parts are priced at $1,544.

How much does it cost to replace air suspension?

Active Suspension Air Spring Replacement Cost – RepairPal Estimate. Labor costs are estimated between $164 and $207 while parts are priced between $1,237 and $1,240. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location.

How do you change a Range Rover wheel?

1. Open the tailgate.
2. Remove the loadspace floor panel.
3. Remove the spare wheel retaining bolt.
4. Remove the vehicle’s jack and the spare wheel lift assist tool.
5. Attach the lift assist tool, as shown.
6. Remove the tool and carefully lift the spare wheel from the vehicle.

How do you remove a locking wheel nut from a Range Rover?

Locate the wheel brace over the locking wheel nut adaptor. Unscrew the wheel nut half a turn counter-clockwise. After raising the vehicle on the jack, remove the locking wheel nut.

How do you change a Land Rover wheel?

Fit the wheel nut brace to the end of the cranking lever. Rotate the handle clockwise to raise, until the jack pin locates into the jacking point. Continue raising the vehicle until the wheel is clear of the ground. Remove the wheel nuts and place them together where they cannot roll away.

How do you change a tire on a Land Rover Discovery sport?

1. Place a wheel wedge or heavy rock by tires to prevent your car from rolling.
2. Loosen the lug nuts.
3. Jack up your SUV.
4. Remove the lug nuts.
5. Remove the flat tire and replace with your spare.
6. Replace the lug nuts and hand-tighten.

Where is the spare tire in a Land Rover?

How do I remove my discovery 5 spare wheel?

Where do you put the jack on a Range Rover?

Position the jack under the relevant jacking point (1) under the floor. Do not allow the jack to contact the sill at any other point, as damage may result. Turn the jack lever (2) clockwise to raise, until the jack head locates into the jacking point.

Can you drive your Range Rover in access height?

Can I drive my Range Rover Sport in access height?

The full access height setting is 2 in (50 mm) below the normal height setting. Auto access height can be activated until 90 seconds after the vehicle becomes stationary. … Alternatively drive the vehicle at a speed above 4.4 mph (7 km/h) for 3 seconds, or at a speed in excess of 9.3 mph (15 km/h).