Turn the jack lever (2) clockwise to raise the jack, until it locates into the jacking point. Make sure that the base of the jack is in full contact with the road surface. Raise the vehicle with the jack, until the tyre being lifted just clears the ground. Operate the jack with a slow and steady motion.
Likewise, how do you lift a Range Rover with air suspension? Up button: Press and release to raise the suspension height. If a door is open, press and hold to raise the suspension height. The button’s LED indicator lamp illuminates during suspension height adjustment and extinguishes when complete. Down button: Press and release to lower the suspension height.
Also, can you jack up a car with air suspension? Just jack it up like normal from ride height. Of course, you can air up higher if you need the clearance. If you’re doing any suspension work, dump the pressure once it’s on jack stands.
Furthermore, where are the jacking points on a Range Rover Sport? To raise the vehicle, use the jacking points located on the front and rear of the side tubes, fixed side steps, or deployable side steps.
Also know, where do you put the jack on a Range Rover? Position the jack under the relevant jacking point (1) under the floor. Do not allow the jack to contact the sill at any other point, as damage may result. Turn the jack lever (2) clockwise to raise, until the jack head locates into the jacking point.
- Press and hold to raise the rear suspension.
- Press and hold to lower the rear suspension.
- Simultaneously press and hold both buttons to set the rear suspension to the normal height setting. A time delay may be evident before the vehicle reacts to a suspension height request via the buttons.
Contents
How do you reset the air suspension on a Range Rover?
How do you lift a car with air bags?
How do you maintain air suspension?
Where would one most likely find the air suspension system disable switch on a vehicle?
Prior to jacking or lifting a vehicle with air suspension, you must turn off the suspension switch. The switch is generally located in the trunk or on the right side of the passenger foot well.
Can I drive my Range Rover Sport in access height?
The full access height setting is 2 in (50 mm) below the normal height setting. Auto access height can be activated until 90 seconds after the vehicle becomes stationary. … Alternatively drive the vehicle at a speed above 4.4 mph (7 km/h) for 3 seconds, or at a speed in excess of 9.3 mph (15 km/h).
Can you drive your Range Rover in access height?
How do you change the wheels on a Range Rover Sport?
- Open the tailgate.
- Remove the loadspace floor panel.
- Remove the spare wheel retaining bolt.
- Remove the vehicle’s jack and the spare wheel lift assist tool.
- Attach the lift assist tool, as shown.
- Remove the tool and carefully lift the spare wheel from the vehicle.
How do you jack up a Discovery sport?
- Locate the jack under the relevant jacking point.
- Unfold the cranking handle from its stowed position on the jack.
- Rotate the handle clockwise to raise, until the jack pin locates into the jacking point.
- Continue raising the vehicle until the wheel is clear of the ground.
How do you jack up a Range Rover Evoque?
Fit the wheel nut brace to the end of the cranking handle. Rotate the handle clockwise to raise the jack, until the jack pin locates into the jacking point. Raise the vehicle until the wheel is clear of the ground. Remove the wheel nuts.