To raise the vehicle, use the jacking points located on the front and rear of the side tubes, fixed side steps, or deployable side steps. The deployable side steps must be in the stored position and the system switched off when raising the vehicle.
Another frequent question is, how do you lift a Range Rover with running boards?
Furthermore, how do you turn on and off side steps on a Range Rover?
Also know, how do you reset the side steps on a Range Rover?
Also, how do you lift a Range Rover with air suspension? Up button: Press and release to raise the suspension height. If a door is open, press and hold to raise the suspension height. The button’s LED indicator lamp illuminates during suspension height adjustment and extinguishes when complete. Down button: Press and release to lower the suspension height.DEPLOYABLE SIDE STEPS. The deployable side steps are full length steps that are stowed below the side sills and under the vehicle. When a door is opened, the side step on that side of the vehicle deploys. If doors on both sides are opened, both side steps deploy.
Contents
How do I turn off deployable side steps?
Get in car. Hold that button and start up the car. Button light will blink. Side steps are now off and will stay closed when doors are opened.
How do you use the side steps on a Range Rover?
Operation of the side steps on one or both sides of the vehicle is dependent on the following unlocking status: When the smart key is set to single-point entry, on the first press of the smart key, the side step deploys on only the driver’s side. A second press also deploys the passenger side step.
How do you turn a Range Rover off?
How do you jack up a Range Rover Sport?
Turn the jack lever (2) clockwise to raise the jack, until it locates into the jacking point. Make sure that the base of the jack is in full contact with the road surface. Raise the vehicle with the jack, until the tyre being lifted just clears the ground. Operate the jack with a slow and steady motion.
How do you raise the suspension on a Range Rover Sport?
- Press and hold to raise the rear suspension.
- Press and hold to lower the rear suspension.
- Simultaneously press and hold both buttons to set the rear suspension to the normal height setting. A time delay may be evident before the vehicle reacts to a suspension height request via the buttons.
Where is the jack in a Range Rover?
If side steps or tubes are fitted, the jacking points are located on the underside of the side step or tube brackets. Before raising the vehicle, correctly position the wheel chocks. See USING WHEEL CHOCKS. Before raising the vehicle or changing a wheel, make sure to read and comply with the following warnings.
Why does my Range Rover turn off when I stop?
2016 Range Rover Sport. The Intelligent stop/start system is designed to improve fuel efficiency and is automatically activated when the vehicle’s ignition is switched on. Unless it is required to support other vehicle systems, the engine will switch off if the vehicle is stopped, for example, at traffic lights.
How do you turn off the stop start on a Range Rover Sport?
Touch the A OFF icon on the lower touchscreen to deactivate the auto stop/start system. The auto stop/start system is automatically deactivated if Hill Descent Control (HDC) or certain terrain response special programs are selected.
Does Range Rover Sport have Auto Hold?
The brake hold functions operate in Reverse (R), Neutral (N), Drive (D) and Sport (S). Brake hold maintains hydraulic brake pressure in the braking system until the accelerator pedal is applied. To hold the vehicle whenever it is at a standstill, automatically applying the brakes to prevent vehicle roll back.
Can I drive my Range Rover Sport in access height?
The full access height setting is 2 in (50 mm) below the normal height setting. Auto access height can be activated until 90 seconds after the vehicle becomes stationary. … Alternatively drive the vehicle at a speed above 4.4 mph (7 km/h) for 3 seconds, or at a speed in excess of 9.3 mph (15 km/h).