How to reset check engine light on 2011 range rover sport?

1. Turn off your vehicle and put on the proper safety gloves and glasses.
2. Locate your battery under the hood and find the negative terminal.
3. Use a wrench to loosen the negative terminal connector.
4. Carefully hold it to the side for 30 to 60 seconds.

Also, how do you reset a Range Rover Sport 2011?

1. Press and hold the trip reset button.
2. Turn the ignition switch on to the ignition position II (one position before starting engine).
3. If the SII (Service Indicator Interval) function is enabled the information display will flash ‘SERVICE’ for 5 seconds and then display ‘SERVICE’ constantly.

People ask also, can you reset check engine light yourself? Insert the key in the ignition, turn the car on for a second, and turn it off for another second. Repeat this process three times. Once you turned your car on/off three times, the check engine light should go away by itself.

Likewise, how do you clear the code on a Range Rover?

1. use a code reader.
2. disconnect the battery leads for a couple minutes.
3. cycle the key on and off more than 40 times. Note, this one requires the problems to be fixed before it worksthe other 2 ways do not, although the codes will return in 2 trips, otherwise.

Also know, why is my check engine light on my Range Rover Sport? 2020 Land Rover Range Rover Sport Check Engine Light Flashing. … Back-up active reasons for a Check Engine Light are a malfunction with the fuel injection system, damaged oxygen sensor, faulty head gasket, faulty emissions control part, dirty mass airflow sensor, or defective spark plugs to name a few.

1. Turn off your vehicle and put on the proper safety gloves and glasses.
2. Locate your battery under the hood and find the negative terminal.
3. Use a wrench to loosen the negative terminal connector.
4. Carefully hold it to the side for 30 to 60 seconds.

How do you reset the service light on a 2012 Range Rover Sport?

How do I clear my check engine light without a scanner?

How do I turn my check engine light off?

How far do you have to drive to reset the check engine light?

To make sure the check engine light does not reappear, it’s recommended that you drive your car 30 to 100 miles. This enables the vehicle’s “Drive Cycle” to reset, as the various sensors need time to recalibrate.

How do you reset a Range Rover sport computer?

1. To reset the device, simultaneously press the Power on and Volume up button for 10 – 12 seconds.
2. The device will power down and then automatically reboot.
3. Device will now power on, perform and charge as expected.

How do you reset the engine management light?

An even simpler way to clear the engine management light is to turn the ignition on and off. This approach achieves the same outcome as the previous step, but without disconnecting the battery. Turn the ignition on and off three times, pausing a second between each cycle. The engine management light should go off.

How do you reset the service light on a 2013 Range Rover Sport?

Turn the ignition to “on” without igniting your engine (if you have push-button start, press your button once without touching the brake pedal. Open the driver’s door. Depress and hold the gas and brake pedals for 60 seconds. Then turn the ignition to “off” and verify that the light has been reset.

How do you reset the service light on a Range Rover Sport?

How do you reset the service light on a 2017 Range Rover Sport?

How do you reset the service light on a 2015 Range Rover Sport?