If the battery has been discharged or disconnected, Apply Foot And Park Brake will be displayed in the Message center when the ignition is next switched on. Press the brake pedal and pull the EPB switch up to apply the EPB. This is required to reset the EPB system. The EPB will now function correctly.
Also, how do I reset my electronic handbrake?
- Block the drive wheels.
- Turn the ignition switch to the ON/RUN position with the engine OFF.
- Place the automatic transmission in PARK or manual transmission in NEUTRAL, as equipped.
- Apply and hold the brake pedal.
- Press and hold down the electronic park brake (EPB) switch approximately 5 seconds.
People ask also, how do you unlock the handbrake on a Range Rover?
Also know, how do you release the parking brake on a Range Rover Sport? Press the brake pedal and press down on the EPB switch. This will release the EPB. Pull up the EPB switch and release it to apply the EPB. The EPB warning lamp will illuminate to indicate that the EPB is applied.
Likewise, how do you adjust the handbrake on a Range Rover Sport?
To reset the parking brake, press and hold the foot brake. While holding the foot brake in position, move the parking brake switch to the ‘Apply’ position. If the electrical supply is disconnected from the parking brake control module, the actuator will loose its position memory.Contents
How do you reset the service brake light?
- Handle Check. The parking brake light may remain on if you have not fully lowered the handle.
- Add Brake Fluid.
- Repair brake fluid leaks.
- Parking Brake Switch Repair.
- Repair of Faulty Brake Sensors.
- Anti-lock Brake System Repair.
How do you turn the parking brake off on a Range Rover?
Where is the handbrake on a Range Rover Sport?
On Discovery 3 and 4 and Range Rover Sport 1 models the electronic park brake system comprises four main parts: the driver’s switch in the cab, the brake module mounted in the centre of the chassis infront of the spare wheel, the cables that run from the module to the wheel brakes to operate them, and the brakes …
How do you manually release the parking brake on a Range Rover?
- With the ignition switched on, press the brake pedal and press down on the EPB switch. This will release the EPB.
- With the vehicle stationary, pull the EPB switch up and release it, to apply the EPB.
How do you put a Range Rover in service mode for brakes?
What is parking brake fault?
Electric Parking Brake Module Failure If your parking brake is making a screeching sound and the parking sensor light is flashing, this is usually a sign that your Electric Parking Brake Module has failed. If you try to drive your vehicle under this circumstance, it can cause damage to the braking system.
How do you override an electric handbrake?
With the AUTO switch OFF, the EPB can be applied by pushing and holding the parking brake switch. This will work with the ignition switch ON or OFF and with the vehicle moving or stationary. To release the brake, pull and hold the manual switch while at the same time pressing the brake pedal.
How do you adjust the handbrake on a Land Rover?
How do you reset the handbrake on a Discovery 3?
With the Engine running, press the brake pedal fully on and off 3 times. On the third press, hold the brake pedal down. With the brake pedal still in the down position, pull the EPB switch upwards 4 times and then downwards 3 times. This must be completed within 10 seconds.
How do I remove EPB from Discovery 3?
The parking brake can be released manually in the Discovery 3 and 4 by removing the small rectangular plastic cover situated just behind the parking brake lever and on the Range Rover Sport by unscrewing the 2 screws that hold the EPB lever in place, inside is a wire cable loop, pulling this will release the parking …