Hold the Valet button on the nav for a minute or so and the menu pops up.
Moreover, how do I put my Range Rover into service mode?
In this regard, how do you get to the service menu on a Range Rover Sport?
Also know, how do you put a Range Rover in service mode 2016? To put in Service mode: In the car with ignition in Position II, press the brake pedal three times and hold the pedal down. Push down on the EPB switch for 3-5 seconds. Go to the main fuse box in the engine bay and remove FL8 fuse 30A (pink Fuse) this will ensure that the EPB is not accidentally re-engaged.
People ask also, how do you get to the message center on a Range Rover?
Contents
How do you lift a Range Rover with air suspension?
Up button: Press and release to raise the suspension height. If a door is open, press and hold to raise the suspension height. The button’s LED indicator lamp illuminates during suspension height adjustment and extinguishes when complete. Down button: Press and release to lower the suspension height.
How do I check my Range Rover Evoque service?
How do I reset my Range Rover valet mode?
- From the Home menu screen, select Valet.
- Enter a memorable 4 digit PIN. You will be prompted to confirm the PIN. If you wish to cancel the PIN, select Delete.
- Valet mode activated is displayed to indicate that a PIN has been accepted.
How do you reset the service required on a Range Rover Evoque?
Where is the handbrake on a Range Rover Sport?
On Discovery 3 and 4 and Range Rover Sport 1 models the electronic park brake system comprises four main parts: the driver’s switch in the cab, the brake module mounted in the centre of the chassis infront of the spare wheel, the cables that run from the module to the wheel brakes to operate them, and the brakes …
How do you use the handbrake on a Range Rover?
With the ignition switched on, press the brake pedal and press down on the EPB switch. This will release the EPB. With the vehicle stationary, pull the EPB switch up and release it, to apply the EPB. The Parking brake warning lamp will illuminate to indicate that the EPB is applied.
Where is the handbrake in a Range Rover?
The Electric Parking Brake (EPB) switch is located on the switch pack between the steering wheel and the driver’s door. Operate as follows: With the ignition switched on, press the brake pedal and pull the EPB switch out to release the EPB.
How do you change the clock on a Range Rover Evoque?
Firstly, you need to click the time display which appears at the right top of the central console which will bring you down to the date and time settings screen. You can now adjust the time accordingly using the up and down arrow in the 24 hr or AM/PM time format and then you finally click the set button.
What is EPB service mode?
The EPB system will fully apply and release the parking brake to guarantee sufficient air gap between the rear brake pads and brake disc. Whenever a technician is performing a repair on a power steering system component, the question is always whether or not there is a need to flush the entire system.
How do you release the parking brake on a Range Rover?
