How do you reset a range rover?

Amazingly, how do you reset a Range Rover computer?

1. To reset the device, simultaneously press the Power on and Volume up button for 10 – 12 seconds.
2. The device will power down and then automatically reboot.
3. Device will now power on, perform and charge as expected.

Furthermore, how do you reset the 2016 Range Rover?

In this regard, how do you reset a Range Rover Sport ECU?

Beside above, how do you reset a 2014 Range Rover?

1. use a code reader.
2. disconnect the battery leads for a couple minutes.
3. cycle the key on and off more than 40 times. Note, this one requires the problems to be fixed before it worksthe other 2 ways do not, although the codes will return in 2 trips, otherwise.

How do I get my Range Rover out of valet mode?

1. From the Home menu screen, select Valet.
2. Enter a memorable 4 digit PIN. You will be prompted to confirm the PIN. If you wish to cancel the PIN, select Delete.
3. Valet mode activated is displayed to indicate that a PIN has been accepted.

How do you reset the check engine light on a Range Rover?

1. Turn off your vehicle and put on the proper safety gloves and glasses.
2. Locate your battery under the hood and find the negative terminal.
3. Use a wrench to loosen the negative terminal connector.
4. Carefully hold it to the side for 30 to 60 seconds.

How do you reset a Range Rover Evoque?

How do you reset the service light on a 2015 Range Rover?

1. Key on, engine OFF.
2. Open door.
3. Open bonnet (hood)
4. Depress the accelerator pedal simultaneously for ten seconds, release.
5. service interval is now reset.

How do you reset the suspension on a 2006 Range Rover Sport?

What does gearbox fault mean on a Range Rover?

The gearbox fault message is often triggered by insufficient battery voltage. It’s a strange sort of Land Rover code – you know, gearbox fault REALLY means battery bad.

What is HDC fault Land Rover?

A message that says “HDC System Not Available” means that your HDC system is failing. … Causes of HDC failure can usually be connected with other mechanical issues in your vehicle. One issue could be a battery problem. The HDC system requires a well-charged vehicle battery to startup the system upon ignition.

How do you reset the service light on a 2011 Range Rover?

How do you reset the service light on a 2009 Range Rover?

How do you reset the engine management light?

An even simpler way to clear the engine management light is to turn the ignition on and off. This approach achieves the same outcome as the previous step, but without disconnecting the battery. Turn the ignition on and off three times, pausing a second between each cycle. The engine management light should go off.