The EKA code is found on the security information card supplied with your vehicle. The code is 4 digits long. The EKA code IS NOT the code in the key fob.
Also know, how do I find my Immobiliser code? Immobiliser codes are available online using the Vehicle Identification Number VIN, Auto Locksmiths & Auto Electricians can use the Immobiliser Code, Emergency Key Access Code (EKA) or IMMO code to start your car or van.
Likewise, how do I bypass my Land Rover Immobiliser?
People ask also, how do you enter the EKA code on a Range Rover P38?
Also, how do you code a Land Rover key?
- Stand outside of the Range Rover with all of the doors of the vehicle closed. On the integrated remote fob and key unit, hold down the “Lock” button continuously.
- Continue to keep the “Lock” button of the fob held down. Rotate the key clockwise in the door lock.
To reset the immobilizer, hold down the panic button. Wait for ten minutes if you push the lock button two times.
Contents
How do I change my immobilizer code?
What is a EKA code?
Emergency Key Access Code. The EKA code is found on the security information card supplied with your vehicle. … The grey plastic tag on the keys IS NOT the EKA code, it is the ignition key code. The EKA code has no connection with the key fob. If you have a new key fob programmed the EKA code will not change.
How do you unlock a Range Rover without a key?
Can you disable a car Immobiliser?
People can use a certain method to disable immobilizer system and however most famous method is by reprogramming EEPROM chip on ECU. … Suppose you lose your car key then you must remove car immobilizer from your car. You can strip little insulation off every wire which ensures that it could not touch each other.
What is a Nanocom?
Custom Remap for the TDV6 – EMS Flash File [NANOCOM] A custom VBF Remap file that can be programmed into the engine management using our diagnostic server based systems applicable to Discovery 3 / LR3 or Pre 2010 Range Rover Sport with a TDV6 Diesel Engine.
How do I program a P38 key?
How do you start a discovery key?
How do you pair a Range Rover key?
- Enter the vehicle and make sure that all doors are shut and locked.
- Insert the new key into the ignition switch.
- Turn the key to position 1.
- Within 25 seconds perform the following steps.
- Press and hold the unlock button on the remote.
- Press the lock button 3 times.
How do you resync a Range Rover key?
Stop holding the “Lock” button on your key fob once the key is clear of your door. The Range Rover and the key fob will synchronize and your remote buttons can then control your vehicle’s lock functions.
How do you reset a Land Rover key?
Put the key in the driver door. Turn it to lock while pressing the lock pushbutton. Hold for 5 seconds. Turn to unlock, press unlock and hold 5 seconds.