Turn half a turn counter-clockwise. Position the jack under the relevant jacking point (1) on the vehicle. Do not allow the jack to contact the sill at any other point, as damage may result. Turn the jack lever (2) clockwise to raise the jack, until it locates into the jacking point.
Correspondingly, how do you lock the air suspension on a Range Rover? 2016 Range Rover Make sure that the suspension height is set at the access height setting or the normal height setting. Make sure that the vehicle is travelling at a speed of less than 35 km/h (22 mph). Press the down button (2) for longer than 1 second, to lock the vehicle at access height.
Furthermore, how do you reset the air suspension on a Range Rover l322?
Subsequently, can you lift a Range Rover? The Land Rover Discovery also offers an electronic air suspension as an upgrade, which means you can change the ride height while driving with the push of a button. … The Off-Road 2 setting lifts the Discovery 75mm (2.95 inches) above normal height. Above speeds of 50 mph, the suspension will go back to normal height.
Beside above, how do you use a Land Rover jack? Turn the jack lever (2) clockwise to raise the jack, until the jack head locates into the jacking point. Make sure that the base of the jack is in full contact with the road surface. Raise the vehicle using the jack, with a slow steady operation.
Contents
Where is the jack in a Range Rover?
If side steps or tubes are fitted, the jacking points are located on the underside of the side step or tube brackets. Before raising the vehicle, correctly position the wheel chocks. See USING WHEEL CHOCKS. Before raising the vehicle or changing a wheel, make sure to read and comply with the following warnings.
How does air suspension work on Range Rover?
The design of the air suspension in the Land Rover is impressive. The suspension is controlled electronically and allows the driver to make adjustments. The way the suspension is able to adjust is by a compressor connected to each individual air strut. The air suspension really does make for a smoother and better ride.
How do you reset a Range Rover?
- To reset the device, simultaneously press the Power on and Volume up button for 10 – 12 seconds.
- The device will power down and then automatically reboot.
- Device will now power on, perform and charge as expected.
How do I find a leak in my air suspension?
How do you reset suspension height on a Range Rover?
Selecting a new height using the raise/lower switch 1, or driving off will reset the system. If the vehicle is grounded and traction control is activated, Extended mode is activated automatically to raise the vehicle clear.
What does air suspension inactive mean on a Range Rover?
The reason it went up when they cleared the code is because they reactivated the system and the compressor filled the system… For it to just sink and throw the inactive message up minutes after the codes were cleared means there is something physically wrong, the system is losing air.
What is HDC inactive?
A message that says “HDC System Not Available” means that your HDC system is failing. … Causes of HDC failure can usually be connected with other mechanical issues in your vehicle. One issue could be a battery problem. The HDC system requires a well-charged vehicle battery to startup the system upon ignition.
How do you raise a Land Rover?
How do you raise the suspension on a Range Rover Sport?
- Press and hold to raise the rear suspension.
- Press and hold to lower the rear suspension.
- Simultaneously press and hold both buttons to set the rear suspension to the normal height setting. A time delay may be evident before the vehicle reacts to a suspension height request via the buttons.