How to reset computer on range rover?

1. To reset the device, simultaneously press the Power on and Volume up button for 10 – 12 seconds.
2. The device will power down and then automatically reboot.
3. Device will now power on, perform and charge as expected.

Also, how do I reset my 2018 Range Rover?

People ask also, how do I reset my Range Rover transmission?

1. Press Start button but don’t turn on the engine.
2. Press the Accelerator down to the floor for about 15 seconds.
3. Hit the start button again to turn off the power.
4. Remove foot from Accelerator.
5. Waity for 2 Mins.
6. Start the engine and Drive.

Likewise, how do you reset the ECU on a Range Rover Sport?

Also know, how do you reset a Range Rover Sport?

1. use a code reader.
2. disconnect the battery leads for a couple minutes.
3. cycle the key on and off more than 40 times. Note, this one requires the problems to be fixed before it worksthe other 2 ways do not, although the codes will return in 2 trips, otherwise.

What does gearbox fault mean on a Range Rover?

The gearbox fault message is often triggered by insufficient battery voltage. It’s a strange sort of Land Rover code – you know, gearbox fault REALLY means battery bad.

How do I reset my Range Rover Smart Key?

Position the Smart key flat against the side of the steering column. There are markings on the steering column to help locate the correct position. While holding the Smart key in position, firmly press and hold the brake pedal. Press and release the engine START/STOP button.

How do you reset the suspension on a 2006 Range Rover Sport?

What is HDC fault?

HDC is sensitive to differences in voltage across the vehicle’s electrical systems. … If you see the “HDC Fault System Not Available” message while the brake warning light or ABS warning light are illuminated, this can indicate a failure in any or all of these systems.

How do you reset the check engine light on a 2008 Range Rover Sport?

1. Turn off your vehicle and put on the proper safety gloves and glasses.
2. Locate your battery under the hood and find the negative terminal.
3. Use a wrench to loosen the negative terminal connector.
4. Carefully hold it to the side for 30 to 60 seconds.

How do you reset a Range Rover Evoque?

How do I factory reset my Range Rover Evoque?

1. Go to Settings menu.
2. Select “Backup & Reset”, select “Factory data reset”
3. Select “Reset phone” and “Erase everything”
4. The device will then reboot.

What does F mean on Range Rover Sport?

references to F are for farenheit which would be out of context. Don’t you have a check engine lite where we could read the codes to see why is not letting you shift out of drive and is displaying F (fault)…check your owners manual would be more authority on this.

How do you reset the 2016 Range Rover?

Turn the ignition to “on” without igniting your engine (if you have push-button start, press your button once without touching the brake pedal. Open the driver’s door. Depress and hold the gas and brake pedals for 60 seconds. Then turn the ignition to “off” and verify that the light has been reset.

How do you reset the engine management light?

An even simpler way to clear the engine management light is to turn the ignition on and off. This approach achieves the same outcome as the previous step, but without disconnecting the battery. Turn the ignition on and off three times, pausing a second between each cycle. The engine management light should go off.