1 Ensure that the ignition is switched off. 2 Press and hold the LH instrument pack button. 3 With the button held, switch the ignition on to position I (AUX). 4 Continue to hold the LH instrument pack button for a further 5 seconds, until the “SIA RESET” appears.
Likewise, how do you reset a 2006 Range Rover Sport?
- Release the TRIP RESET button within 10 seconds of entering the reset mode, the information display will show “DIST” or “OIL”
- Press the TRIP RESET button within 10 seconds of releasing it and hold for more than 5 seconds.
Also know, how do you reset a Range Rover computer?
- To reset the device, simultaneously press the Power on and Volume up button for 10 – 12 seconds.
- The device will power down and then automatically reboot.
- Device will now power on, perform and charge as expected.
People ask also, how do you reset a Range Rover Sport ECU?
Also, how do you reset a Range Rover l322?
- use a code reader.
- disconnect the battery leads for a couple minutes.
- cycle the key on and off more than 40 times. Note, this one requires the problems to be fixed before it worksthe other 2 ways do not, although the codes will return in 2 trips, otherwise.
Contents
How do I reset my Range Rover Smart Key?
Position the Smart key flat against the side of the steering column. There are markings on the steering column to help locate the correct position. While holding the Smart key in position, firmly press and hold the brake pedal. Press and release the engine START/STOP button.
How do I get my Range Rover out of valet mode?
- From the Home menu screen, select Valet.
- Enter a memorable 4 digit PIN. You will be prompted to confirm the PIN. If you wish to cancel the PIN, select Delete.
- Valet mode activated is displayed to indicate that a PIN has been accepted.
How do I reset my Range Rover gearbox?
- Press Start button but don’t turn on the engine.
- Press the Accelerator down to the floor for about 15 seconds.
- Hit the start button again to turn off the power.
- Remove foot from Accelerator.
- Waity for 2 Mins.
- Start the engine and Drive.
What is HDC fault Range Rover?
A message that says “HDC System Not Available” means that your HDC system is failing. … Causes of HDC failure can usually be connected with other mechanical issues in your vehicle. One issue could be a battery problem. The HDC system requires a well-charged vehicle battery to startup the system upon ignition.
How do you jumpstart a 2006 Range Rover?
How do you reset the service light on a 2005 Range Rover Sport?
What does gearbox fault mean on a Range Rover?
The gearbox fault message is often triggered by insufficient battery voltage. It’s a strange sort of Land Rover code – you know, gearbox fault REALLY means battery bad.
How do you reset the service light on a Range Rover?
Press and hold the trip reset button. Turn the ignition switch on to the ignition position II (one position before starting engine). If the SII (Service Indicator Interval) function is enabled the information display will flash SERVICE for 5 seconds and then display SERVICE constantly.
How do you reset the check engine light on a 2008 Range Rover Sport?
- Turn off your vehicle and put on the proper safety gloves and glasses.
- Locate your battery under the hood and find the negative terminal.
- Use a wrench to loosen the negative terminal connector.
- Carefully hold it to the side for 30 to 60 seconds.
How do you reset the engine management light?
An even simpler way to clear the engine management light is to turn the ignition on and off. This approach achieves the same outcome as the previous step, but without disconnecting the battery. Turn the ignition on and off three times, pausing a second between each cycle. The engine management light should go off.