- Press Start button but don’t turn on the engine.
- Press the Accelerator down to the floor for about 15 seconds.
- Hit the start button again to turn off the power.
- Remove foot from Accelerator.
- Waity for 2 Mins.
- Start the engine and Drive.
Also, how do you reset the gearbox on a Range Rover Sport? 1) Press Start button but don’t turn on the engine. 2) Press the Accelerator down to the floor for about 15 seconds. 3) Hit the start button again to turn off the power. 5) Waity for 2 Mins.
People ask also, how do I unlock my Range Rover Gear?
Also know, what does gearbox fault mean on a Range Rover? The gearbox fault message is often triggered by insufficient battery voltage. It’s a strange sort of Land Rover code – you know, gearbox fault REALLY means battery bad.
Likewise, what is Gearbox fault detected? A ‘Gearbox Fault Detected’ warning message may be displayed on the . If the vehicle is in PARK, the customer may not be able to select DRIVE or, if already in DRIVE, the customer may experience a ratcheting type noise followed by an abrupt stop when the vehicle speed has reduced to 5 km/h (3 mph).
Contents
How do you clear the code on a Range Rover?
- use a code reader.
- disconnect the battery leads for a couple minutes.
- cycle the key on and off more than 40 times. Note, this one requires the problems to be fixed before it worksthe other 2 ways do not, although the codes will return in 2 trips, otherwise.
What does transfer box neutral mean?
It’s only used to force the transfer box shift motor to select (transfer box) neutral when the vehicle has to be towed on all four wheels if you’re broken down. You can try to use it here to reset the transfer box ECU so it learns where it’s shift fork is : Phil.
How do I get my Range Rover out of park?
- Turn the locking mechanism 90° anti-clockwise.
- Press the brake pedal.
- Use the strap to pull the transmission park release mechanism upwards, until it latches in the vertical position.
How do you put a 2013 Range Rover in neutral?
What is a transmission fault?
The Car Has No Power: If your car has no power and your engine is properly working, your transmission is failing. The internal parts of the system are starting to shut down. This could happen because there is a leak somewhere within the system. … If so, this means your car is probably leaking transmission fluid.
What is HDC fault system not available?
A message that says “HDC System Not Available” means that your HDC system is failing. … Causes of HDC failure can usually be connected with other mechanical issues in your vehicle. One issue could be a battery problem. The HDC system requires a well-charged vehicle battery to startup the system upon ignition.
How do you check the transmission fluid on a 2013 Range Rover Evoque?
- Turn the car on.
- Find the transmission fluid dipstick.
- Remove the dipstick and touch the fluid, moving it around between your thumb and forefinger.
- Use a rag to wipe off the dipstick.
- Use a funnel to bring the fluid level up to the right spot.
How do I reset my Range Rover Smart Key?
Position the Smart key flat against the side of the steering column. There are markings on the steering column to help locate the correct position. While holding the Smart key in position, firmly press and hold the brake pedal. Press and release the engine START/STOP button.
What is HDC fault?
HDC is sensitive to differences in voltage across the vehicle’s electrical systems. … If you see the “HDC Fault System Not Available” message while the brake warning light or ABS warning light are illuminated, this can indicate a failure in any or all of these systems.