In drivers seat, all doors closed, turn key to run, engine off. Within 4 seconds push the ‘O’ button, for the odometer, twice. Within 10 seconds turn the key off, to lock position, where you can take the key out.
In this regard, how do you reset the oil light on a Mercedes c230? Locate the trip odometer reset button to the left of the instrument panel. Hold the reset button for a few seconds until the screen displays the message, “Do you want to reset the service interval? Confirm with the R-button.” Release the button once the phrase appears.
Additionally, how do you reset the maintenance light on a 1999 Mercedes c230? Diagnostic Reset Tool Required (please refer to TOOLS page) Manual Reset. Turn key in steering lock to position 2. Within 4 seconds press 0 button twice. The present status for days or distance displays, within 10 seconds turn the electroninc key in steering lock to position 0.
Also know, how do you reset the check engine light on a Mercedes c230 Kompressor?
- Wear safety glasses and gloves.
- Turn off the ignition, and open the hood.
- Locate the battery and find the negative terminal.
- Remove the cable from the terminal using a wrench.
- Hold the negative cable to the side for 30-60 seconds.
- Be careful not to let the cables touch.
People ask also, how do you reset service light on Mercedes w202? Press and hold 0 button while turning electronic key in steering loack to position 2 again. The present status for days or distance displays once more. Continue to hold 0 button for approximately 10 seconds until a signal sounds and the display shows 10 000 (15000KM) for approximately 10 seconds.
Push and HOLD the RESET button located in the LEFT corner of the Instrument Cluster until you see the Reset instructions on the screen. Once more, push and HOLD the RESET button until you hear a BEEP.
How do you reset the oil light on a Mercedes?
How do you reset the service light on a w203?
How do I clear my check engine light without a scanner?
How do you turn off the engine management light on a Mercedes?
To reset a check engine light without a scanner, disconnect the negative battery cable and wait a few moments. This will reset the diagnostic system in your vehicle, and if the underlying issue has indeed been resolved, the light should go off immediately.
How do I permanently turn off my check engine light?
How do you reset the check engine light on a Mercedes c180?
Locate the reset button on the left side of the instrument cluster. Press the reset button and hold it until the display reads “To reset: Press reset button for 3 seconds.” Push the reset button again and hold the button in until the display indicates that the system has been reset.