How to reset mercedes benz c300 service indicator?

Correspondingly, how do you reset the service light on a 2015 Mercedes c300?

In this regard, how do I reset my Mercedes service message?

1. Turn the ignition switch using your key to the “II” position.
2. Press the trip odometer reset button twice within one second.
3. Turn the ignition switch to the “0” position.
4. Press and hold the trip odometer reset button.

Also know, how do you reset the service indicator on a Mercedes C Class?

Subsequently, how do you reset the service light on a 2010 Mercedes c300?

What does service B mean on a Mercedes?

Service B is a Service Interval in the Mercedes-Benz Flexible Service System that is recommended every 20,000 miles or 12-months after your Mercedes-Benz Service A, for 2009 and newer Mercedes-Benz. Your vehicles maintenance service indicator will also notify you when your next maintenance service is due.

How do you reset the service light on a 2017 Mercedes c300?

How do you reset the service light on a 2015 Mercedes C Class?

How do you reset the service light on a Mercedes C Class 2018?

Where is the reset button in Mercedes?

How do I reset my Mercedes computer?

1. Turn the ignition key to the on (not start) position.
2. Press the gas pedal to the floor and hold for five seconds.
3. Turn the key to the “off” position (don’t remove the key), then release the gas pedal.
4. Wait at least two minutes for ECU to reset.

How do you reset service B exceeded Mercedes?

How do you reset the service indicator on a Mercedes C Class w203?

How do you reset the check engine light on a Mercedes c300?

To reset a check engine light without a scanner, disconnect the negative battery cable and wait a few moments. This will reset the diagnostic system in your vehicle, and if the underlying issue has indeed been resolved, the light should go off immediately.

What is service B in Mercedes c300?

Service B involves: Replacing the oil filter and Mercedes-Benzes motor oil. Inspecting and correcting tire pressure. Checking fluid levels and modifying them according to the manufacturer’s instructions. Replacing the cabin dust/combination filter.