Shift the selector level in each position. Then shift it in the “P” position, and run the engine at idling speed. Pull out the dipstick and check the fluid level on the gauge. If it is below the lower level on the “HOT” side, add the recommended automatic transmission fluid up to the upper level.
Also, how do you check the transmission fluid on a 2010 Subaru Forester? Find the transmission dipstick, which is usually brightly colored and toward the back of the engine. Remove the dipstick, being careful not to spill or drip any fluid. Wipe off the dipstick with a clean rag, just as you would do when checking the engine oil.
People also ask, how do you check the transmission fluid on a 2008 Subaru Forester?
Also know, where is the transmission dipstick on a Subaru? Open the hood and pull out the looped handle in the back of the engine. This is the transmission dipstick.
Likewise, how do you check the transmission fluid on a 2009 Subaru Outback?
Valvoline – DEXRON®-VI ATF Full Synthetic Automatic Transmission Fluid, 1 Gallon (Part No. 883572)Contents
Where is the transmission dipstick?
First, locate the transmission dipstick, which can be found under the hood, in the engine compartment. Make sure you are locating the transmission dipstick and not the engine-oil dipstick; the transmission dipstick is usually further back in the engine bay, toward the firewall (the bulkhead at the front of the cabin).
How do you check the transmission fluid on a 2011 Subaru Forester?
Find the transmission dipstick, which is usually brightly colored and toward the back of the engine. Remove the dipstick, being careful not to spill or drip any fluid. Wipe off the dipstick with a clean rag, just as you would do when checking the engine oil.
How much transmission fluid does a Subaru Forester hold?
The transmission fluid capacity on the Forester is 9.8 US quarts. If You are also looking for which transmission fluid to use, then Subaru ATF or Idemitsu ATF HP are recommended.
How do you check the transmission fluid on a 2010 Subaru Legacy?
How do you fill transmission fluid in a Subaru?
You’ll need a funnel and a bendy tube that can reach down to the transmission dipstick hole to fill it back up. Stick one end of the bendy tube into the dipstick hole and attach the funnel to the other end. Carefully pour in the transmission fluid. Be careful not to overfill the transmission with fluid.
Where do I add transmission fluid?
Insert long funnel into automatic transmission fluid dipstick hole. Carefully add automatic transmission fluid in small increments and recheck level each time until fluid level reaches “warm” line. CAUTION: DO NOT OVERFILL OR SPILL AUTOMATIC TRANSMISSION FLUID ON HOT ENGINE PARTS!
How do you add transmission fluid?
How do you check the transmission fluid on a Subaru Forester?
Automatic Transmission Fluid Park on a level surface and set the parking brake. Shift the selector level in each position. Then shift it in the “P” position, and run the engine at idling speed. Pull out the dipstick and check the fluid level on the gauge.
What are the signs of low transmission fluid?
- Noises. If your transmission is working properly, you shouldn’t hear any noise while you’re driving as it should transition smoothly.
- Burning Smell. Any foul smell coming from your car should direct you to your nearest service center.
- Transmission Leaks.
- Slipping Gears.
How do you check transmission fluid?
- Pull out the dipstick. With the engine on and the gearshift in Neutral or Park and the parking brake on, let your engine run.
- Check the fluid.
- Wipe the dipstick with a clean, lint-free rag; then reinsert it and pull it out again.