Find the transmission dipstick, which is usually brightly colored and toward the back of the engine. Remove the dipstick, being careful not to spill or drip any fluid. Wipe off the dipstick with a clean rag, just as you would do when checking the engine oil.
People also ask, how do you check the transmission fluid on a Subaru Forester? Automatic Transmission Fluid Park on a level surface and set the parking brake. Shift the selector level in each position. Then shift it in the “P” position, and run the engine at idling speed. Pull out the dipstick and check the fluid level on the gauge.
Correspondingly, how do you check transmission fluid in 2010?
Similarly, how do you check the transmission fluid on a 2009 Subaru Forester?
Also know, what kind of transmission fluid goes in a 2010 Subaru Forester? The 2010 Subaru Forester uses API GL-5 75w-90 oil for manual transmissions. For automatic transmissions, Subaru recommends using Subaru ATF Idemitsu ATF hp “Dexron iii” type automatic transmission fluid. It is recommended to change Your transmission fluid every 80,000 miles.Find the transmission dipstick, which is usually brightly colored and toward the back of the engine. Remove the dipstick, being careful not to spill or drip any fluid. Wipe off the dipstick with a clean rag, just as you would do when checking the engine oil.
Contents
How do you check the transmission fluid on a 2010 Subaru Legacy?
What are the signs of low transmission fluid?
- Noises. If your transmission is working properly, you shouldn’t hear any noise while you’re driving as it should transition smoothly.
- Burning Smell. Any foul smell coming from your car should direct you to your nearest service center.
- Transmission Leaks.
- Slipping Gears.
How do you check transmission fluid without a dipstick?
How do I know if my transmission fluid is low?
- Park vehicle on level surface, engage parking brake and start engine.
- Locate automatic transmission fluid dipstick, typically near where the transmission or transaxle meets rear of the engine.
- Remove automatic transmission fluid dipstick.
- Observe markings at end of dipstick.
What kind of transmission fluid does a 2011 Subaru Forester take?
Lubegard Synthetic Synthetic Transmission Fluid Dexron VI 1 Quart.
What kind of transmission fluid does a 2009 Subaru Forester use?
Valvoline – DEXRON®-VI ATF Full Synthetic Automatic Transmission Fluid, 1 Gallon (Part No. 883572)
How do you check the transmission fluid on a 2008 Subaru Outback?
How much transmission fluid does a Subaru Forester hold?
The transmission fluid capacity on the Forester is 9.8 US quarts. If You are also looking for which transmission fluid to use, then Subaru ATF or Idemitsu ATF HP are recommended.
How often should you change transmission fluid in Subaru Forester?
Most new vehicles are equipped with an automatic transmission. As a result, there’s not really much maintenance to perform. Still, most owner’s manuals will recommend changing the transmission fluid every 90,000 miles or so.
What happens if I accidentally drained my transmission fluid?
If you had drained the fluid by mistake, all you have to do is put the fluid back in the hole where you pull the dipstick out. Check the fluid level again with the engine running, make sure the fluid level is up to the FULL mark line.