Without starting the car, turn the key to the “On” position. Press the TPMS reset button and hold it until the light blinks three times, then release it. Start the car and let it run for 20 minutes to reset the sensor. You’ll usually find the tire pressure monitor reset button beneath the steering wheel.
People ask also, where is the TPMS reset button on a Subaru? This button can be located in the dash, below the steering wheel. Hold down the button for a count of about 10 to 20 seconds, during which the tpms light on Your dash will begin to flash constantly. Once the flashing begins, You will need to remove Your finger from the button, and start Your engine.
Moreover, how do you reset the TPMS on a 2019 Subaru Outback? It’s usually located on the driver’s side door jamb. Then, drive around for a few minutes at a speed of 25 miles per hour. Once You’re done driving You can park Your car and turn the engine off. Your TPMS should now be reset.
Frequent question, how do you reset the TPMS light on a 2018 Subaru Outback? To reset the tpms on the 2018 subaru outback make sure the tire pressure is correct, then turn on the vehicle. Now hit the reset button that is to the right of the steering wheel and wait ten minutes. In some cases you may need to hold the button down till the light flashes.
Quick Answer, how do you reset the tire pressure light on a 2016 Subaru Outback? To reset the tire pressure monitor or tpms system in your 2016 subaru outback vehicle, turn the ignition key to the “on” position and depress the tpms button, usually located under the dash, until the tpms light blinks several times.Run for 20 minutes while the system records the new pressure of each tire and turn the ignition off. Restart the car and the TPMS warning should be switched off. To reset the 2009 subaru outback tire pressure light press and hold the tpms reset button until the light blinks three times.