In regards to, how do you reset the maintenance light on a 2016 4Runner? To reset the maintenance light on a Toyota 4Runner, you must turn the ignition switch to the “ON” position, then set the trip display to “ODO” mode, turn the ignition switch to “OFF,” then press and hold the trip “RESET” button, while turning the ignition to the “ON” position.
Similarly, how do I turn off the maintenance required light on my Toyota 4Runner? Press the ODOMETER/TRIP button again, and hold it down while You turn the ignition back on. If You have a push button start, press it twice like You did earlier. Continue pressing the ODOMETER/TRIP button and You’ll see 000000 MILES appear. The maintenance light should go off.
Beside the above, how do you clear the maintenance light on a Toyota 4runner? Continue to hold the “Odometer/Trip” button while switching the ignition of the vehicle on. On push button models, press the Engine Start button two times without holding the brake. Do not start the engine. When the odometer displays all zeros, it will confirm the maintenance light has been reset.
Moreover, how do you reset the maintenance light on a 2017 Toyota 4runner?
Contents
How do you reset the maintenance light on a 2018 Toyota 4runner?
How do you reset the maintenance required light on a 2016 Toyota Corolla?
How do you reset the maintenance light on a 2014 Toyota 4runner?
Where is the oil filter on a 2016 Toyota 4runner?
How do you reset the maintenance light on a 2012 Toyota 4runner?
Turn the engine on and then find the reset button which is located to the right and bottom of the steering wheel on the instrument panel. Press and hold the reset button once You have found it. Keep holding it until the TPMS indicator light slowly blinkS3 times.
How do I reset my Toyota maintenance message?
Push and hold the trip meter reset button on the dashboard, then turn your key to the second position. Continue to hold the odometer button for 10 seconds total. This should cause the light to flash, possibly beep, then turn off. After it’s off, release the odometer button then start the car.
How do you reset the maintenance required light on a Toyota?
How do you reset the maintenance required light?
- Turn ignition switch to the ON position.
- Set the Odometer/Trip Display to TRIP A mode.
- Turn the ignition switch to the OFF position.
- Depress and HOLD the Trip Meter RESET button while turning the ignition switch to the ON position.
- The Service Maintenance Reminder Light will.
How often should I change my oil in my Toyota 4Runner?
Toyota recommends getting your 2021 Toyota 4Runner oil & filter changed every 3,000-5,000 miles for conventional oil. Synthetic oil usually should be changed every 7,500 – 10,000 miles. Keep in mind it’s best to check your owner’s manual and with your dealer to find out the intervals that work best for your vehicle.
What type of oil does a 2016 Toyota 4Runner take?
The 2016 Toyota 4Runner uses a full synthetic oil type at SAE 0W-20 viscosity. The SUV’s 4.0L V6 engine has an oil capacity of 6.6 quarts, when added with a filter.
How much oil does a 2016 4Runner take?
Capacity: 6.6 quarts. (with filter)After refill check oil level.
How do you reset the maintenance required light on a 2019 Toyota 4runner?
How do you reset the maintenance required light on a Toyota Tacoma?
- Press the “Power” button once without holding the brake to activate the electronics.
- Use the Left and Right arrows to select the “Gear”
- Use the Up and Down arrows to select “Settings“, then press .
- Use the arrows to select “Maintenance Reset“, then press .
- Select “Yes“, then press .