Resetting the SRS Light To do this, turn the key in the ignition, but do not start the car. Just turn it far enough to turn on the electrical. As soon as the SRS indicator light turns off, then turn the key to the off position and then turn it on again.
Correspondingly, how do you reset the airbag light on a Toyota? Take a paperclip and unfold it. Jump the wire by attaching one end of the paperclip to each of the two terminals. This will reset the SRS light. Put the yellow electrical connector back in place and close the panel cover.
People ask also, how do I reset my 2010 Toyota Corolla?
In this regard, how do I reset my solid airbag light?
- Put the key into the ignition and turn the switch to the “on” position.
- Watch for the airbag light to turn on. It will stay illuminated for seven seconds and then shut itself off. After it shuts off, immediately turn the switch off and wait three seconds.
- Repeat Steps 1 and 2 two more times.
Quick Answer, how do I turn my airbag light off?
- Turn on the ignition switch with your car key.
- Wait for the airbag warning light to turn off.
- Turn the ignition switch of your car back off for a little longer than three seconds.
- Repeat steps 1 through 3 twice to make three times total.
Contents
Will disconnecting battery reset airbag light?
Often, all it takes to get rid of that pesky warning light is to reset your airbag sensor. … Remove the terminal clamp and leave it disconnected for 5-10 seconds to allow the airbag sensor to reset. Then reconnect the battery terminal and turn the vehicle on. With a bit of luck, the light will stay off.
What does it mean when the airbag light stays on?
The airbag light indicates that something is wrong with the seatbelts or airbags. This means that it’s probably not safe to drive with the airbag light on. If it stays illuminated in your vehicle, we recommend having it towed to the dealership rather than driving it yourself.
Can I drive my car if the airbag light is on?
If the airbag light is on, it means that the airbag will not be able to deploy in the event of an accident. This is a dangerous proposition, and it means that you should avoid driving if at all possible in that vehicle.
How much does it cost to fix airbag light?
Number 1 — Reset Airbag Light You’ll need to hire a professional to come in and examine the airbags before you continue to drive the car. This process can take several hours of time and usually costs a few hundred dollars, although depending upon the type of car it may be up to about $600.
What is the tire pressure for a 2010 Toyota Corolla?
2010 Toyota Corolla Tire Pressure Recommended tire pressure for 2010 Toyota Corolla is 30 psi to 32 psi for front tires and 30 psi to 32 psi for rear tires.
How do you reset the maintenance light on a 2009 Toyota Corolla?
What does the maintenance required light mean on a 2010 Toyota Corolla?
What Is the Maintenance Required Light? The Toyota maintenance light can appear on your dashboard as “MAINT REQD”. It’s a light that remains active permanently, letting you know that you need to go for an oil change in a certified auto shop.
Is there a fuse for the airbag light?
What fuse is the airbag fuse? In most models, this is fuse #40, located in the lower right corner of the fuse block. The SRS light is a warning light for your supplemental restraint system (airbags).
Can a blown fuse cause the airbag light to come on?
Blown fuses can definitely cause the airbag light to come on. When the airbag system is malfunctioning, a mechanic or auto parts store should be able to read the code that the system is putting out which will give them a clue as to what particular problem the airbag is having.