To do this, turn the key in the ignition, but do not start the car. Just turn it far enough to turn on the electrical. As soon as the SRS indicator light turns off, then turn the key to the off position and then turn it on again. Repeat this procedure about 5-7 times.
Also, how do you reset the airbag light on a Toyota? Take a paperclip and unfold it. Jump the wire by attaching one end of the paperclip to each of the two terminals. This will reset the SRS light. Put the yellow electrical connector back in place and close the panel cover.
In this regard, how do you reset the airbag light on a 2007 Toyota Corolla?
- Remove the fuse panel cover under the steering column by pulling down on it with your fingers.
- Locate the yellow SRS electrical connector in the fuse panel.
- Turn the ignition key to the “On” position (the second position in the ignition).
People ask also, how do I turn my airbag light off?
- Turn on the ignition switch with your car key.
- Wait for the airbag warning light to turn off.
- Turn the ignition switch of your car back off for a little longer than three seconds.
- Repeat steps 1 through 3 twice to make three times total.
Furthermore, how do I reset my solid airbag light?
- Put the key into the ignition and turn the switch to the “on” position.
- Watch for the airbag light to turn on. It will stay illuminated for seven seconds and then shut itself off. After it shuts off, immediately turn the switch off and wait three seconds.
- Repeat Steps 1 and 2 two more times.
Often, all it takes to get rid of that pesky warning light is to reset your airbag sensor. … Remove the terminal clamp and leave it disconnected for 5-10 seconds to allow the airbag sensor to reset. Then reconnect the battery terminal and turn the vehicle on. With a bit of luck, the light will stay off.
Contents
What does it mean when the airbag light stays on?
The airbag light indicates that something is wrong with the seatbelts or airbags. This means that it’s probably not safe to drive with the airbag light on. If it stays illuminated in your vehicle, we recommend having it towed to the dealership rather than driving it yourself.
How do you reset the airbag light on a 2008 Toyota Corolla?
Resetting the SRS Light To do this, turn the key in the ignition, but do not start the car. Just turn it far enough to turn on the electrical. As soon as the SRS indicator light turns off, then turn the key to the off position and then turn it on again. Repeat this procedure about 5-7 times.
How do you read Toyota airbag codes?
What does the airbag symbol look like?
the srs warning light on the dashboard usually looks like a side view of a person sitting in a seat with a seat belt on, with a large circle (the airbag) in front of the person. it will normally light up briefly each time you start your vehicle, and then go off.
Is it illegal to drive with airbag light on?
It is not safe to drive with the airbag light ON. When the light is on, it means that there is a problem with the airbag system. When there is a problem with the system, it will not deploy the airbags at all in an accident. It is always recommended to repair the problem as soon as possible.
How much does it cost to reset the airbag light?
Number 1 — Reset Airbag Light You’ll need to hire a professional to come in and examine the airbags before you continue to drive the car. This process can take several hours of time and usually costs a few hundred dollars, although depending upon the type of car it may be up to about $600.
Will removing fuse disable airbag?
Every vehicle I’ve worked on has had an airbag fuse you can remove from the fuse panel to fully disable the airbag; the repair manuals recommend pulling this fuse when doing any work in the dash area since there’s some risk of triggering the airbags to go off while you’re working, which could result in serious injury …
Is there a fuse for the airbag light?
What fuse is the airbag fuse? In most models, this is fuse #40, located in the lower right corner of the fuse block. The SRS light is a warning light for your supplemental restraint system (airbags).
Can a blown fuse cause the airbag light to come on?
Blown fuses can definitely cause the airbag light to come on. When the airbag system is malfunctioning, a mechanic or auto parts store should be able to read the code that the system is putting out which will give them a clue as to what particular problem the airbag is having.