Put your foot on the brake and press the power button to turn the system on. Press and hold the TPMS reset button located below the steering wheel until the TPMS indicator light flashes slowly three times. Wait for a few minutes and then turn the vehicle off.
Also the question is, how do you reset the tire pressure light on a 2010 Toyota Prius?
Moreover, why is my tire pressure light still on after filling tires? If you’ve added air but the air pressure warning light stays on, there’s a problem with your Tire Pressure Monitoring System or you have a slow leak. … Quick Tip: If the TPMS warning light comes back on after you’ve filled the tire with air, recheck the tire to make sure it is inflated to the proper air pressure.
In this regard, how do you reset the tire pressure light on a 2006 Toyota Prius?
Also know, why won’t my low tire pressure light go off? What if corrected the tire pressure and my tire pressure light still won’t turn off? … When the TPMS warning light comes ON and stays ON, this indicates a low tire pressure condition in one or more tires. Inflating the tire to the recommended tire pressure found on the door placard should cause the light to turn OFF.Press and hold the TPMS reset button located below the steering wheel until the TPMS indicator light flashes slowly three times.
Contents
The TPMS reset button is usually located beneath the steering wheel. If you are unable to find it, refer to your vehicle’s owner’s manual. Inflate all tires to 3 PSI over their recommended amount, then deflate them completely. Be sure to include the spare tire, as it may have a sensor as well.
Is it normal for tires to lose pressure?
About 1-3 psi per month is normal for air loss, but you still should check inflation rates often, and re-inflate your tires. Neglecting tire inflation for 6 months may take out 6-18 psi, and with the most frequent recommended rate being 30-35 psi, this is a big loss.
Why is my TPMS not working?
TPMS problems can include any of the following: A TPMS sensor that has stopped functioning because the battery has died. A TPMS sensor that is working intermittently due to a weak or failing battery. The TPMS module is not receiving a signal from one or more sensors because of an antenna or wiring fault.
How do you reset the maintenance required light on a 2007 Toyota Prius?
What does a solid tire pressure light mean?
A TPMS warning light that illuminates solid and remains solid usually means that one or more of the tires has low air pressure and needs to be inflated to the correct placard pressure. However, a light that flashes for 60-90 seconds and then illuminates solid is signaling that there is a problem with the TPMS system.
Can you replace the battery in a tire pressure sensor?
Most TPMS sensors run on batteries that are built into the sensor and these batteries are not replaceable. The life expectancy of the lithium ion batteries in a TPMS sensor is anywhere from 5-10 years. … If one of your TPMS sensors fails and needs replacement, you can replace it individually.
How do you reset a low tire light?
Turn the car key to “on” but don’t start the vehicle. Press and hold the TPMS reset button until the tire pressure light blinks three times. Release the button and start the car. The light should go off within 20 minutes.
What should I do if my tire pressure is low?
- Remove the Valve Stem Cap. Unscrew the plastic cap that sits over the valve stem.
- Use a Tire Pressure Gauge to Measure the Existing Pressure.
- Check the Recommended Tire Pressure for Your Car.
- Inflate the Tires Using an Air Pump.
- Inflate the Tires at the Nearest Gas Station (Optional)
How do I know if my tire pressure sensor is bad?
How do you put air in a Prius tire?
- Park your vehicle by the air dispenser.
- Remove the cap from the tire valve on the first tire.
- Use your tire gauge to check the air pressure in the tire.
- Use the air hose to add air in short bursts.
- Keep checking the pressure until you get it right.