You asked, how do you reset the maintenance required light on a Toyota Prius? Turn the vehicle completely off. Press and hold the “Trip” or “MPH” button. Continue to hold the “Trip” or “MPH” button while switching the ignition to “On” without starting the engine. Release the button when the trip meter is set to all zeros.
Amazingly, how do you put a Prius 2008 in maintenance mode?
Likewise, how do you reset the code on a 2008 Prius? Hold down your car brake and press the power button to turn the car on. Continue holding down the brake, as you press the odometer trip button. Turn the car off while holding the ODO button and brake. After doing so, turn the car back on one more time while still on brake and ODO.
Beside above, how do you reset the maintenance required light on a 2007 Toyota Prius? To turn off the maintenance required light on Your 2007 Toyota Prius hold in the brake and press the start until the car turns on. With the odometer displayed, not the trip meter, press and hold the ODO trip reset button.To reset your prius simply press the power button once to power your prius down. Press and hold down the odo button and press the power button twice (2x) with your foot off the brake.
Contents
How do I turn off the maintenance required light?
Why won’t my Toyota Prius turn off?
When your Prius won’t shut off, the most common cause is the combination meter. The combination meter is the gauge with green LEDs behind the steering wheel. It has the speedometer, fuel gauge, and shift selector position as well as a few other things.
What does Prius maintenance mode do?
Putting your Toyota Prius into maintenance mode – getting the engine to stay running. … Normally the engine only runs to either warm itself up or if the driver is requesting more power, but if you want the engine to idle you’re stuck.
Can I drive my Prius in B mode all the time?
Simply put, it’s best to avoid using B mode on your shifter during regular driving. There is no advantage to using the mode when it isn’t required, as it throws energy away unnecessarily, and doesn’t recharge the hybrid battery.
How do you reset the dash light on a Prius?
Keep holding the Prius trip reset button and turn your key back towards the “Off” position. Turn your Prius key to the “On” position. Continue holding your Prius reset button until you see the number near the odometer reach 0. You’ve succeeded in resetting your Toyota maintenance light!
How do you reset the code on a Prius?
- Connect the scan tool to the onboard diagnostic connector. This is found under the steering column.
- Press the READ button on the scan tool, and look for any error codes.
- Press the ERASE button on the tool to remove the error code. The check engine light will then turn off.
What does the red triangle mean on a toyota prius?
If You happen to see a red triangle light come on at Your dash in Your Toyota Prius that is its version of a standard check engine light. … The red triangle warning light on a toyota prius is the check engine light and should be brought to a dealership, it could range from low oil pressure to something more serious.
How do you reset the maintenance required light on a 2006 Toyota Prius?
How do you turn off the tire pressure light on a 2007 Toyota Prius?
Press and hold the TPMS reset button which is located below the steering wheel and hold it until the TPMS indicator light flashes slowly three times. Wait for a few minutes and then turn the Prius off and then start it up and the light should be gone.