Depress and hold the “ODO/TRIP” button until the odometer display confirms that reset has begun (odometer reads “1”). Once reset is complete, the odometer returns to normal. Release the button.
Quick Answer, how do I reset my fuel gauge?
- Turn the ignition switch to the on position.
- Press the Odo / Trip button until the odometer is in ODO mode.
- Turn off the ignition.
- Press and hold the Odo / Trip button.
- Release the Odo / Trip button.
Best answer for this question, how do you reset the fuel gauge on a 2009 Prius?
Likewise, how do you reset the fuel gauge on a 2005 Prius?
Furthermore, how do you reset the fuel gauge on a 2008 Prius?
Look for the fuel pump switch or inertia switch. This is a small box with a plastic button on top and an electrical connector at the bottom. On some vehicle models, this will be located in the luggage compartment. Look on a side panel for a small, round button which you can pry off with a small screwdriver.Contents
How do you fix an inaccurate fuel gauge?
- Turn the ignition on and off a few times, and observe if the needle on the fuel gauge moves.
- Test the grounding wire on the sending unit of the fuel tank.
- Disconnect the wiring connected to the sending unit of the fuel gauge and then look at the fuel gauge.
Why is my gas gauge reading wrong?
The most common problem that causes the fuel gauge to read incorrectly is a bad fuel sending unit. … This ensures that the driver is aware of the fuel level at all times, as well as warn when the vehicle is low on fuel, and when to visit a gas station before the tank is completely empty.
What would cause the gas gauge to stop working?
What Causes The Fuel Gauge Not To Work? … An inaccurate fuel tank reading is most commonly caused by the sending system which reads the fuel tank level and sends the reading to the gauge. Issues can also stem from a bad gauge, blown fuses, or corroded wiring. You can self-test all of these parts at home with a few tools.
How do you calibrate a Toyota fuel gauge?
Hold the ODO button for two seconds. Release and press the ODO button three more times within five seconds: Release-Press-Release-Press-Release-Press and Hold. Continue to hold the ODO button for at least five seconds until the leveling information is displayed on the odometer.
How do you reset the fuel gauge on a Toyota Corolla?
Depress and hold the “ODO/TRIP” button until the odometer display confirms that reset has begun (odometer reads “1”). Once reset is complete, the odometer returns to normal. Release the button.
How do I reset my 2004 Prius?
Hold the Start button down with your index finger for at least 45 seconds. Step 2: Restart the car. Start the car normally after the system has rebooted by pushing down on the brake and pressing the Start button again.
How do you fill up a Prius?
How do I know how much gas is in my car?
- Check the manual. By checking your car’s manual, you can easily determine how much your gas tank could hold.
- Check the odometer. Check the odometer in order to determine how many miles you have traveled.
- Use a liquid dipstick.
Is there a fuse for fuel pump?
Replacing Fuel Pump Fuse Most fuel pumps will run a 15 (Blue) 20 (Yellow) or 25 (Clear) amp fuse. Using a fuse that’s too small will cause the fuse to blow again. This is a normal condition as the fuse isn’t rated for the higher amps of a fuel pump circuit.
Where is the fuel relay switch located?
Most fuel-pump relay units are located under the dashboard near the steering column. In some cases, the unit is located in the area where the steering column is mounted or near the engine’s firewall.