Press and hold the TPMS reset button which is located below the steering wheel and hold it until the TPMS indicator light flashes slowly three times. Wait for a few minutes and then turn the Prius off and then start it up and the light should be gone.
Also know, where is Prius TPMS reset button? Press and hold the TPMS reset button located below the steering wheel. Release the button after the low-pressure light blinks three times.
People ask also, how do I reset my Toyota air pressure sensor? Resetting Your Toyota Tire Pressure Light With the vehicle off, turn the key to the “On” position, but don’t start the car. Hold the TPMS reset button until the tire pressure light blinks three times, then release it. Start the car and wait 20 minutes for the sensor to refresh.
Likewise, how do you reset the TPMS light on a 2008 Prius?
Also, where is the TPMS reset button? The TPMS reset button is usually located beneath the steering wheel. If you are unable to find it, refer to your vehicle’s owner’s manual. Inflate all tires to 3 PSI over their recommended amount, then deflate them completely. Be sure to include the spare tire, as it may have a sensor as well.
Contents
Why is my tire pressure light still on after filling tires?
If you’ve added air but the air pressure warning light stays on, there’s a problem with your Tire Pressure Monitoring System or you have a slow leak. … Quick Tip: If the TPMS warning light comes back on after you’ve filled the tire with air, recheck the tire to make sure it is inflated to the proper air pressure.
How do you reset the low tire pressure light on a 2010 Toyota Prius?
To reset the tire pressure sensor for the toyota prius, press and hold the tpms reset button under the steering wheel. Release the button after the low pressure light blinks three times. Let the engine run for 20 minutes so the computer can calibrate the sensor. Then turn the ignition off.
How do you reset the tire pressure light on a 2009 Toyota Prius?
How do you know which tire sensor is bad?
How do I get the TPMS light to go off?
When the TPMS warning light comes ON and stays ON, this indicates a low tire pressure condition in one or more tires. Inflating the tire to the recommended tire pressure found on the door placard should cause the light to turn OFF.
Some Toyota models have a “SET” or “TPMS RESET” button, which is located below the steering wheel or under the glovebox. When the button is pressed, the system tries to locate the sensor ID’s that are already stored.
What does a solid tire pressure light mean?
A TPMS warning light that illuminates solid and remains solid usually means that one or more of the tires has low air pressure and needs to be inflated to the correct placard pressure. However, a light that flashes for 60-90 seconds and then illuminates solid is signaling that there is a problem with the TPMS system.
What does TPMS sensor look like?
Can I reset the TPMS by disconnecting the battery?
Find the battery and disconnect the negative battery cable. You will need a wrench to do this. Once the battery is disconnected, turn your vehicle on and press the horn for approximately three seconds. This will drain any remaining energy stored in the vehicle’s electrical system.