Furthermore, how do you reset the maintenance light on a Toyota Rav4? Put your key in the ignition and turn it to position one, which is the position right before starting the car. Push and hold the trip meter reset button on the dashboard, then turn the key to position two. Keep holding the odometer button for 10 seconds. The light should then flash, beep, and then go out.
Amazingly, how do you reset the maintenance light on a 2012 Rav4?
- Put your key in the RAV4’s ignition.
- Push and hold the trip meter reset button on the dashboard.
- Hold the odometer button for ten seconds.
- Once the light goes out, release the odometer button and start the car.
Additionally, how do you reset the maintenance light on a 2014 Toyota Rav4?
Best answer for this question, how do you reset the maintenance required light on a 2012 Toyota Rav4?
Contents
How do you reset the maintenance light on a 2015 Toyota RAV4?
To reset the maintenance light on a 2015 toyota Rav4, first turn the ignition to on, then set the odometer to read “odo”. Turn ignition to off. Push and hold the trip reset button at the same time turning the ignition back to on.
How do you turn off the maintenance required light on a 2015 Toyota RAV4?
How do you turn off the AWD on a 2013 Toyota RAV4?
Well, the “Lock” button is actually used to switch the RAV4 to all wheel drive. Here’s how it works. dash light will illuminate to indicate AWD is turned on. Press “Lock” again to turn it off.
How do you reset the maintenance required light?
- Turn ignition switch to the ON position.
- Set the Odometer/Trip Display to TRIP A mode.
- Turn the ignition switch to the OFF position.
- Depress and HOLD the Trip Meter RESET button while turning the ignition switch to the ON position.
- The Service Maintenance Reminder Light will.
How do you reset the maintenance light on a Toyota Rav4 2017?
What does it mean when my Toyota Rav4 says maintenance required?
The icon MAINT REQD meaning is important. When the MAINT REQD light goes on it indicates that the vehicle’s scheduled maintenance is due. This service may be covered under your ToyotaCare plan if your vehicle is less than two years old.
Why is my AWD light on RAV4 2013?
The awd light in your 2013 toyota Rav4 may indicate a problem with your vehicle’s wheel bearings, speed sensors or both.
Why is my AWD light on RAV4?
If Your check engine light and AWD lights are both on in Your 2015 Toyota RAV4 that usually means that there was a problem detected with the all wheel drive system. … The most common reason that You will get a check engine light is a loose gas cap which will be detected as a vacuum leak.
How do you turn on the AWD on a 2013 Toyota RAV4?
How do I reset my Toyota maintenance?
- Turn Your Vehicle on. Your key should be switched to the on position and look on your dashboard.
- Turn the Vehicle Off and Press the Trip Meter Reset Button.
- Turn the Vehicle Back on.
- Keep the Reset Button Pressed.
- Release the Reset Button.