You asked, how do you reset the maintenance light on a 2013 Toyota Rav4?
Beside above, how do I reset the maintenance required light on my Toyota Rav4? Put your key in the ignition and turn it to position one, which is the position right before starting the car. Push and hold the trip meter reset button on the dashboard, then turn the key to position two. Keep holding the odometer button for 10 seconds. The light should then flash, beep, and then go out.
Moreover, how do you reset the maintenance required light on a 2012 Toyota Rav4?
- Turn on your car without starting.
- Make sure you are on TRIP A screen.
- Switch off the ignition.
- Hold down the ODO/TRIP button while turning the car back on.
- Keep holding it until you see zero and you’re done.
Subsequently, how do you reset the maintenance required light on a 2014 Toyota Rav4?
The icon MAINT REQD meaning is important. When the MAINT REQD light goes on it indicates that the vehicle’s scheduled maintenance is due. This service may be covered under your ToyotaCare plan if your vehicle is less than two years old.Contents
How do you reset the maintenance required light on a 2015 Toyota Rav4?
How do I reset my Toyota maintenance?
- Turn Your Vehicle on. Your key should be switched to the on position and look on your dashboard.
- Turn the Vehicle Off and Press the Trip Meter Reset Button.
- Turn the Vehicle Back on.
- Keep the Reset Button Pressed.
- Release the Reset Button.
Why is my maint reqd light on?
What ‘MAINT REQD’ Means. The ‘MAINT REQD’ light comes on every 5000 miles from the last time it was reset. It in no way indicates any system malfunction; it is simply a mileage counter intended to remind the user that an oil change is necessary.
Why is my maintenance required light still on after oil change?
If your maintenance required light is on. It’s because your car thinks it’s gone over a set amount of miles without changing the oil. If you’ve had your oil changed and it’s still on. That’s because whoever changed your oil didn’t reset the light.
How do I reset my maintenance required?
How do you reset the maintenance required light on a 2013 Toyota Corolla?
How do you reset the maintenance light on a 2013 Toyota Sienna?
- Turn on the car without starting the engine.
- Push the ODO/TRIP button repeatedly until you see ODO.
- Turn off the car.
- Hold down the ODO/TRIP button while turn on the car again.
- Keep holding the ODO/TRIP button.
- Release the button and start the engine to confirm that everything is done.
How do you turn off the maintenance required light on a Toyota oil change?
- Start the car and then press and hold the button that changes the odometer reading.
- While you are holding the button, turn the ignition key just slightly so that the vehicle starts without kicking the engine off.
- Release the button and turn off the ignition key.
How do I turn off the maintenance light after an oil change?
Hold the Reset Button and Turn the Key Turn the ignition back to the ON position while holding the reset button. Watch the oil change or maintenance light carefully. It should start to blink. Allow the light to blink ON and OFF for a few seconds, then release the reset button and turn the ignition OFF.