- Put your key in the RAV4’s ignition.
- Push and hold the trip meter reset button on the dashboard.
- Hold the odometer button for ten seconds.
- Once the light goes out, release the odometer button and start the car.
Additionally, how do you turn off the maintenance required light on a Toyota RAV4 push button? Put your key in the ignition and turn it to position one, which is the position right before starting the car. Push and hold the trip meter reset button on the dashboard, then turn the key to position two. Keep holding the odometer button for 10 seconds. The light should then flash, beep, and then go out.
Also the question is, how do you reset the maintenance required light on a 2012 Toyota RAV4?
- Turn on your car without starting.
- Make sure you are on TRIP A screen.
- Switch off the ignition.
- Hold down the ODO/TRIP button while turning the car back on.
- Keep holding it until you see zero and you’re done.
Frequent question, how do you turn off the maintenance required light on a Toyota push start? Push and hold the dashboard odometer button and turn the key to position two. Keep holding the odometer button until the maintenance light starts to flash. You might even hear beeping noises. The light should go out.
Also, how do you turn off the maintenance light on a Toyota RAV4 push button start 2021?
Contents
How do I turn off the maintenance light?
How do I turn off the maintenance required light on my Toyota?
Push and hold the trip meter reset button on the dashboard, then turn your key to the second position. Continue to hold the odometer button for 10 seconds total. This should cause the light to flash, possibly beep, then turn off. After it’s off, release the odometer button then start the car.
How do I turn off the maintenance required light?
- Turn ignition switch to the ON position.
- Set the Odometer/Trip Display to TRIP A mode.
- Turn the ignition switch to the OFF position.
- Depress and HOLD the Trip Meter RESET button while turning the ignition switch to the ON position.
- The Service Maintenance Reminder Light will.
How do you reset the maintenance light on a 2011 Toyota RAV4?
How do you turn off the maintenance required light on a 2014 Toyota RAV4?
How do you clear the maintenance message on a RAV4?
- Turn The Ignition ON. Don’t Start The Engine.
- Press The ODO/TRIP BUTTON To Display To ODO.
- Then Turn The IGNITION To OFF.
- Press And Hold ODO/TRIP BUTTON And Turn Ignition To The “RUN” Position. Hold Knob For At Least 5 Seconds Until “000000” Is Displayed.
- Then Turn The Ignition OFF.
Why is my maintenance required light on Toyota Rav4?
The icon MAINT REQD meaning is important. When the MAINT REQD light goes on it indicates that the vehicle’s scheduled maintenance is due. This service may be covered under your ToyotaCare plan if your vehicle is less than two years old.
How do you turn off the maintenance light on a Toyota 4Runner?
To reset the maintenance light on a Toyota 4Runner, you must turn the ignition switch to the “ON” position, then set the trip display to “ODO” mode, turn the ignition switch to “OFF,” then press and hold the trip “RESET” button, while turning the ignition to the “ON” position.