- Switch the ignition on.
- Open the glove compartment. A red-illuminated button should be visible inside.
- Hold that button for two seconds.
- Viola- the Tire Pressure Monitoring System light should now deactivate.
People ask also, how do you turn off the tire pressure light on a 2014 Volkswagen Jetta?
Likewise, how do you reset the tire pressure light on a 2016 Volkswagen Jetta?
Also know, how do I turn off tire pressure light? Turn the car key to “on” but don’t start the vehicle. Press and hold the TPMS reset button until the tire pressure light blinks three times. Release the button and start the car. The light should go off within 20 minutes.
Also, where is the TPMS reset button? The TPMS reset button is usually located beneath the steering wheel. If you are unable to find it, refer to your vehicle’s owner’s manual. Inflate all tires to 3 PSI over their recommended amount, then deflate them completely. Be sure to include the spare tire, as it may have a sensor as well.If you’ve added air but the air pressure warning light stays on, there’s a problem with your Tire Pressure Monitoring System or you have a slow leak. … Quick Tip: If the TPMS warning light comes back on after you’ve filled the tire with air, recheck the tire to make sure it is inflated to the proper air pressure.
Contents
Why wont my tire pressure light go off?
If you’ve inflated your tires to the proper air pressure, but the warning light stays on, you may have a leak or there’s a problem with the TPMS in one or more of your tires. It’s simple enough to check if there’s a leak in a tire. Just use your tire gauge to recheck the air pressure in all your tires.
What is the correct tire pressure for a Volkswagen Jetta?
Tire Pressure for Volkswagen Jetta Recommended tire inflation for Volkswagen Jetta is 32 psi to 35 psi for front tires and 32 psi to 35 psi for rear tires.
How do I reset my VW warning light?
- Turn your key into the on position.
- Select the Settings menu.
- Select the Service submenu.
- Select Reset option.
- Press OK.
- Press OK again to confirm.
Can you turn off the tire pressure monitoring system?
The U.S. Department of Transportation has mandated that all vehicles manufactured after 2008 include a tire pressure monitoring system (TPMS). Although you cannot disable the TPMS in a General Motors (GM) vehicle, you can reset the system if you recently checked your tires and inflated them properly.
What does a solid tire pressure light mean?
A TPMS warning light that illuminates solid and remains solid usually means that one or more of the tires has low air pressure and needs to be inflated to the correct placard pressure. … It can also mean that an incorrect sensor is installed in the tire.
Can I drive with tire pressure light on?
No, driving with the TPMS Light on is not safe. It means one of your tires is underinflated or overinflated. … This can cause undue wear on the tire, potentially lead to a tire failure, and cause a blowout dangerous to you and other drivers on the road.
How do you know if you have a bad TPMS sensor?
TPMS stands for Tire Pressure Monitoring System. In most vehicles the TPMS reset button is found beneath the steering wheel. After changing the tires on your vehicle, the TPMS needs to be electronically reset in order to clear the error code. … Start your vehicle and wait 20 minutes and the sensor will refresh.
Can I reset the TPMS by disconnecting the battery?
Find the battery and disconnect the negative battery cable. You will need a wrench to do this. Once the battery is disconnected, turn your vehicle on and press the horn for approximately three seconds. This will drain any remaining energy stored in the vehicle’s electrical system.
How much does it cost to reset TPMS?
The service kit costs $5-$10 per wheel on most vehicles. A special TPMS tool and additional time are also needed to check and reset the sensor system. In the event pressure sensors need to be replaced, the cost ranges from $50-$250 each depending on vehicle type.