- Make sure your vehicle is off.
- Turn on the Hazard.
- Then hold down the 0.0/SET button while turn the vehicle to the on position.
- After that it’s going to ask you if you want to reset the oil service.
- Finally, turn off the hazarrd and you’re good to go.
As many you asked, how do you reset the oil light on a 2014 Volkswagen Passat? To perform an oil reset on the 2014 vw passat oil you need to turn it on, but do not start the engine. Find the reset button on the console dash and hold it. When the light blinks and stops turn the vehicle off and wait 5 min. Your oil is now reset.
Additionally, how do you reset the oil light on a 2015 Volkswagen Passat? Turn the key into the ON position. Select the “Settings” menu with the controls located on either the windshield wiper arm or the steering wheel. Select the “Service” submenu and then select the “Reset” option and then press the OK button to reset the display. Press the OK button once more to confirm.
Frequent question, how do you reset the service on a 2008 Volkswagen Passat?
People ask also, how do you reset the oil light on a 2013 Volkswagen Passat?
- Turn your key into the on position.
- Select the Settings menu.
- Select the Service submenu.
- Select Reset option.
- Press OK.
- Press OK again to confirm.
Contents
How do you reset the computer on a Volkswagen Passat?
- Turn on the ignition.
- Press and hold the TRIP button on the wiper rod (right side of the handlebar).
- Use the TRIP buttons to navigate and the OK / Reset button to confirm. Go to SETUP → Service Interval → Reset and confirm the reset process.
- Turn off the ignition.
How do I reset the Passblue warning on a VW Passat?
To perform an adblue reset in a 2014 vw passat tdi, turn the ignition to on without starting the engine. Push down on the gas pedal and keep it down until you see the glow plug illuminate again. Wait for it to stop blinking and turn off the ignition.
How do you reset the service light on a 2007 Volkswagen Passat?
How do you reset the service light on a 2009 Volkswagen Passat?
How do you reset the service on a 2006 Volkswagen Passat?
With the ignition off and key out press and hold the service wrench button. With the wrench button still held down insert and press the key to the ON position without actually starting the ignition. Press and hold the MIN clock button on the other side of the steering wheel while keeping the wrench button down.
How do you reset the service light?
How do I clear my check engine light without a scanner?
How often do Volkswagens need oil changes?
According to the Volkswagen site, Volkswagen recommends that you change your vehicle’s oil every 12 months or 10,000 miles, whichever comes first. That means that if you drive less than 10,000 miles per year, you can just set a recurring annual date to get your oil changed and should be good to go.
How do I reset my ECU?
How do I reset my Volkswagen ECU?
If you disconnect one battery terminal for about 30 minutes, it will reset the ECU. You will then need to run a TBA. To run a TBA on later models (I don’t know if this works on AEB) switch ignition on (do not start), wait 2 minutes and switch off.